Question about 2002 Lexus ES 300

2 Answers

2003 ES LEXUS

Hi everyone. Any suggestions of resetting the Check engine indicator? Thanks;

Chris

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Just remove the battery lead and put it back after a minute.

Posted on Oct 30, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Lexus Master
  • 1,861 Answers

It is very difficult to "reset" the check engine light. There is a memory for the codes, and if you COULD reset it, the light will simply just come right back on if you have a bad sensor or something like that. Get it scanned & report the code back to me.

Posted on Sep 12, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Lexus problems


Adjust the rpm, near the throttle body. Or clean the throttle body. If neither of those work, look into the idle air control valve.

Jul 03, 2014 | 2003 Lexus ES 300

1 Answer

2003 lexus es300 won't start... radio lights and windows work. Tried a jump start, still doesnt work...


Are you saying the engine cranks but won't start, or the engine won't crank ?
If the engine does not crank, you would check for voltage at the starter, the neutral safety switch, and the key switch as well as the ground connections.

Sep 18, 2012 | 2003 Lexus ES 300

1 Answer

Reset check engine lite 2002 lexus es 300


The way to stop the check engine light is to pull the error code(s) from the computer and resolve what is indicated. REMEMBER the code is a CLUE and not necessarily the issue, for example, an intake leak can cause a oxygen sensor to register out of range....
The light would reset automatically, in absence of errors.

Nov 01, 2011 | 2002 Lexus ES 300

1 Answer

My 94 lexus es 300 the engine light stays on n sometimes my battery light comes on wat does tat mean


Hi, the engine light is indicating that the computer has detected a fault. You will have to extract the trouble code to determine the fault. Go here for instructions on diagnostics: http://www.clublexus.com/forums/es300-and-es330/324049-obd1-check-engine-light-codes.html
Please get back to me with the results/trouble code for assistance in resolving the fault.

The battery light may be indicating a weak alternator. Check the voltage at the battery with the engine idling. If the voltage is less than 14 volts, replace the alternator.

Mar 16, 2011 | Lexus ES Cars & Trucks

1 Answer

Churping sound upon start up between the firewall and engine. Sounds like a bearing but quites down some after engine running for a couple minutes.


I would try to remove the drive belt(s) and see if the chirping goes away, and also while the belt(s) are off, check that each rotatable pulley turns freely indicating that the bearings are ok.

Oct 28, 2010 | 2003 Lexus ES 300

1 Answer

2003 Lexus es 300 a/c is blowing hot air and the a/c light is blinking put a brand new compressor in there so i know its not that,


Did you check that your compressor has gas? ( special refregiration gas for tht purpose).

also it can be that one of the vents is not working. you know when you put hot on the main board in the car, the vents inside the car change of possition to take vantage of the eat of the engine to heat the interior of the car.

Jul 30, 2010 | 2003 Lexus ES 300

1 Answer

My car gives out alot of white smoke when i start it in the mornings but then it goes away.i have already got the engine overhauled but the problem persists.i have to add 2 litres of oil every...


WHITE SMOKE INDICATE SLIGHT HEAD GASKET.STOP SMOKING WHEN ENGINE GET HOT.HEAD EXPANDS ENOUGH TO STOP THE LEAK.BUT I SEEN CASES WHERE THE HEADS HAD TO BE PRE TORQUE AFTER ENGINE OVERHAUL.ALSO YOUR ENGINE WILL USE OIL UNTIL PISTON RINGS SEAT.SO KEEP EYE ON OIL LEVEL.

Jun 16, 2010 | 2003 Lexus ES 300

1 Answer

In my 1995 ES-300 Lexus....


DO NOT TRY TO REPAIR/REPLACE module yourself unless you have the diagnostic computer to be able to set/reset functions,keys etc.....the check engine light can be reset by a dealer.remember diahatsu is owned by toyota/lexus could work out cheaper calling to see if they are willing to reset

Feb 19, 2010 | 1995 Lexus ES 300

1 Answer

How do I replace owner's manual 2003 Lexus?


You can get your owners manual here:

http://www.lexus.com/cpo/model_library/ES/2003.html

Check bottom left hand screen of this webpage for the manual

Nov 17, 2009 | 2003 Lexus ES 300

3 Answers

Trac off and check engine light for lexus es 300


try to reset this problem , disconnect the negative battery terminal few minutes and reconnect , start the engine

Apr 21, 2009 | 2001 Lexus ES 300

Not finding what you are looking for?
2002 Lexus ES 300 Logo

Related Topics:

294 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...