Question about 1997 Chrysler Town & Country

1 Answer

Spark plugs in a 1997 chystler town and country

How many & howdo I get to them?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

You should have either 4 or 6 spark plugs.



your spark plugs should be in either one of 2 places.
1 while you are stadning in front of the car look down there should be some what looks like black caps with thick wires coming from them. in this position you plugs will be torward the bottom of your engine.
2.look to the right or left of the engine. you should see the same thing black caps with wires comeing out of them. thoses are you plugs. now all you have to do is take one wire off at a time. to do that grasp the lower part of the wire shoudl be the black cap do not pull on the wire it's self you might break the wire. from there you should be able to see the top of the plug.

Please do not forget to rate and comment about your experience today. Thank you.

Posted on Sep 03, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change rear spark plug wires


Go into Youtube and use the following search phrase: "Dodge Caravan Plug Wires." There are about half dozen videos that will show exactly how to do it. Remember, the Chrysler Town & Country and Plymouth Voyager are the same vehicles.

Apr 26, 2015 | 1997 Dodge Caravan

1 Answer

The 1997 town and country transmission I put in my 1996 town and country minivan has a extra plug-in don't have the plug


if the transmission is working as expected I would say that the plug is for the later harness and may have no use in the vehicle. To be sure have an accredited transmission shop check it out But as I said if there is no problems apparent then leave it .

Apr 22, 2014 | 1996 Chrysler Town & Country

1 Answer

Spark plugs


there is a tool available go to autozone for a small deposit they will loan you it remove the top 2 motor mounts these look like dog bones located right on top run from engine to radiator install tool this will pull the engine forward enough to reach the plugs hope this helps

Jan 23, 2014 | 1997 Chrysler Town & Country

1 Answer

1997 town & country stalls intermittently. ... my chrysler town & country lxi dashboard cluster ligths go out


I had the same problem in the past with the lights. I repaired it by removing the the dash panel and re-soldering the pins where the harness plugs into. I am currently having the stall issue. in my research it seems to be the crank shaft sensor. I was told that the crank shaft sensor and the cam sensor work together and have decided to change them both along with the gas filter.

May 27, 2011 | 1997 Chrysler Town & Country

1 Answer

How do u get to rear spark plugs


Post engine type/size please when asking a question.....but usually on the V6 models you have to take the intake plenum off to access the rear plugs and wires.

May 16, 2011 | 1997 Chrysler Town & Country

1 Answer

I have 1997 town and country i replace the crank shaft sensor and it still cut off it still has the code p0340


If this is intermittant , check the wires at the plug. Wires tend to break there the most. To check, and I know this is difficult for the crank sensor, start the car and wiggle the wires as close as you can get to the plug. If the plug plugs into another plug wiggle both sides.
Let me knnow
Randy

Apr 21, 2011 | 1997 Chrysler Town & Country

2 Answers

I want to do a tune up on my 2001 town and country.What do i need to do to get at the back spark plugs?


They are often easiest to change from underneath at the backside of the engine which is very hard to do unless you have it on a hoist.

Jun 01, 2010 | 2001 Chrysler Town & Country

2 Answers

Van will not start . It will not turn over when I try to start it. It is like it is not getting any gas.


1997 town and country alarm is shuting van down how do i disconnect it???????????

May 08, 2010 | 1997 Chrysler Town & Country

1 Answer

How do you change the back 3 spark plugs on a 2000 crysler 3.3


Take the windshield assembly off, takes about 15 minutes - from there it's a breaze.

Jan 06, 2010 | 2000 Chrysler Town & Country

1 Answer

Tune up on cown and country (chrysler)


I just changed the rear spark plugs on my 1997 Chrysler Town & Country this weekend. It took me about 7 hours to do everything. When you replace the rear spark plugs, its a good item to replace everything i have listed below. Listed below are the items i changed while i was in there:

Valve Cover Gaskets
All 6 sparks (the rear are the hardest) I used the Bosch Plat. +4
Intake manifold gasket (only cost $3-4)
Throttle body gasket.
Air filter
Spark Plug Wires

I also bought some throttle body cleaner and sprayed the throttle body to clean it out. When the throttle body is dirty your van can stall.
I took pictures of everything i took apart, which i can email you to help you out.

Thank You,
Nip
Highhrider@aol.com

Sep 14, 2008 | 1998 Chrysler Town & Country

Not finding what you are looking for?
1997 Chrysler Town & Country Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

60667 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21936 Answers

chargerhp
chargerhp

Level 3 Expert

813 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...