My abs light as come on do i have to change my brake pads ???

Brake pad's have nothing to do with ABS ! ABS light lit ,take it an have it checked for DTC'S - diagnostic trouble codes . Same with the other light's . Your best bet , take it to a qualified repair shop .

Is it the "brake"repair light blinking & chiming?? Or is it the "ABS" brake light blinking/chiming. Brake light should be red, ABS amber

DID YOU ROTATE THE BRAKE PISTON BACK IN THE BORE AND INSTALL BRAKE PADS WHERE THE BUTTONS ON THE BACK SIDE OF BRAKE PADS ENGAGE WITH THE ALIGNMENT CUT OUTS AFTER CALIPER BEEN INSTALLED ONTO THE ANCHOR PLATE.SEE IF BRAKE PADS NOT INSTALL RIGHT IT WILL CAUSE ABS LIGHT PROBLEMS.BRAKES WILL DRAG SLOW DOWN PUT DRAG ON THE WHEELS..

this means that one of you abs wheel sensors is not working take voltmeter check each wheel senser there on the caliper around it should be 12 volts then check fluid cause brake fluid set off brake light too but those only two possibilitys

Have you checked the brake fluid level?

Did you bump the ABS pickup at the wheel hub when you changed the brakes? Or are the wires maybe nicked? The noise is normal and might go away depending on the brake pad type you replaced with. The ABS problem might be caused by you.

Its not your brake pads. It is your ABS system. Only dealers are certified to work on the ABS systems. I would check all of your fuses prior to sending it to the dealership. You probaby have a bad sensor. Have you drove through water over your bumpers? IF so, then just take it to the dealer because you have shorted a sensor.

Go back around and check to make sure you didnt accidentally pinch or cut a brake pad sensor. Also the ABS modules on VAG cars are pretty crappy.

Abs and dsc are related and with the light on these won't work. It is possible that you need to go back to where the work was done to look this over.

if you know the code for the radio... unhook the battery for about ten minutes to reset the abs warning.... if it comes back on after that there may be another issue.... but make sure you have the code for the radio or it will become unusable.

Robert