- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
put a prybar between seat and brake pedal and use a test light on the wire in trunk where bulbs are sometimes bulbs look good but aren't or you got wrong bulb. a test light will verify that and make sure test light lights
It could be the turn signal switch, since the brake wire travels through the turn switch after it leaves the brake switch and then goes to the bulbs. That is how you get a steady brake light on one side, and a blinking light on the turning side. The rear turn signal lights and brake lights share the same filament in the bulbs (and the same wire). The wire on the turning side has to first travel through the flasher relay. If you have a test light, first check for power out of the brake light switch with the pedal depressed. Then check for power in and power out at the turn switch connector-power in on the brake light wire and power out on either of the wires going to the rear bulbs-if no power out, the turn switch is bad-brake pedal still depressed so you still have the signal.
The third or High Mounted Brake Light runs straight off the brake light switch on the brake pedal arm. You say you tested the "brake unit"? I assume you mean the third brake light assembly, and if you get power there when someone steps on the brake pedal, then the bulbs are bad.
The power flow for the brake lights goes like this: Fuse ->Brake switch -> Turn signal switch -> Rear lights. The only difference is, if you have a 3rd brake light in your rear window, that gets its power directly from the brake switch. It does not go thru the signal switch first. So, if you are having a brake light problem, and your fuses are good, check the 3rd light in the rear window, if it lights up (assuming the bulbs are good, no one ever changes them), then the problem is most likely in the turn signal switch, hope this helps!
These are Dual Function Bulbs. They control the Parking Lights and the Brake Lights. This Bulb is Burnt out on the Brake Coil inside the Bulb. I have actually seen Bulbs that were Bad But you could not Tell by jast looking at them. It should be fine with a New Bulb. Please Rate My Response! Thanks!