Tip & How-To about Jeep Grand Cherokee

2007 Jeep Grand Cherokee Fluid capacities

SPECIFICATIONS - FLUID CAPACITIES
DESCRIPTION SPECIFICATION FUEL TANK
All Models
76L (20 U.S. Gallons)*

ENGINE OIL
3.0L Diesel with Filter (10.0 Quarts)
3.7L with Filter (5.0 Quarts)
4.7L with Filter (6.0 Quarts)
5.7L with Filter (7.0 Quarts)
6.1L with Filter (7.0 Quarts)
COOLING SYSTEM
3.0L Diesel
13.2L (14.0 Quarts)
3.7L (9 Quarts)**
4.7L (14.5 Quarts)**
5.7L (14.5 Quarts)**
6.1L (14.8 Quarts)**
A/C REFRIGERANT SYSTEM
All Models
0.68 kg (1.5 Pounds)
POWER STEERING SYSTEM
Power steering fluid capacities are dependent on engine/chassis options as well as steering gear/cooler options. Depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these capacities may vary. Refer to 19, Steering for proper fill and bleed procedures.
AUTOMATIC TRANSMISSION
Service Fill - 545RFE
2WD 5.2 L (11 Pints)
4WD 6.2 L (13 Pints)
Service Fill - NAG1
5.0L (10.6 Pints)
Overhaul Fill - 545RFE
13.33L (28.0 Pints)
Overhaul Fill - NAG1
7.7L (16.3 Pints)
TRANSFER CASE
NV140 and NV146
0.65L (1.4 Pints)
NV245
1.8L (3.8 Pints)
FRONT AXLE ± 0.3 L (2 oz.)
C200F
1.7L (57.5 Ounces)
C200FE
1.7L (57.5 Ounces)***
REAR AXLE ± 0.3 L (2 oz.)
C213R
2.07L (70 Ounces)
C213RE
2.24L (75.5 Ounces)***
*Nominal refill capacities are shown. A variation may be observed from vehicle to vehicle due to manufacturing tolerance and refill procedure.
** Includes 0.9L (1.0 Quarts) for coolant reservoir.
***ELSD - add 118 ml (4 Ounces) of friction modifier.
Dry fill capacity. Depending on type and size of internal cooler, length and inside diameter of cooler lines, or use of an auxiliary cooler, these figures may vary.

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

3.8l awd. how much transmission fluid goes in to a completely empty system,and what type of oil for transfer case.


Reference: 3.3/3.8L Fluid Capacities & Specifications - The ...

forum.chryslerminivan.net/.../12671-Reference-3.3-3.8L-Fluid-Capacitie...

May 8, 2009 - 10 posts - ‎2 authors
FLUID CAPACITIES Fuel (Approximate) - 20 US Gallons (76 Liters) Cooling System* 3.3 and 3.8 Liter Engines - 13.23 Quarts (12.5 Liters) NOTE: - *Includes heater and ...1996 Chrysler Town & Country LX [Always and forever the favorite.] ... Does anyone know what the transmission fluid capacity is?

1998 CHRYSLER TOWN AND COUNTRY 3.3L 6-cyl Engine ...

www.amsoil.com/.../vehiclelookup.aspx?...1998+CHRYSLER+T...

Amsoil

Dec 29, 2015 | 1998 Chrysler Town & Country

1 Answer

how to change a fuel filter on a polo vivo 2010


Engine oil: Drain or extract and replenish; renew oil filter Engine oil: Drain or extract engine oil ? Chapter. Renewing oil filter ? Chapter. Replenishing engine oil ? Chapter. Draining or extracting engine oil Special tools and workshop equipment required t Used oil collection and extraction unit -V.A.G 1782- t Oil spill cloth -VAS 6204/1- Draining or extracting engine oil Carry out the following procedure: > Note
t For engines with standing oil filter the oil filter must be renewed before changing the engine oil. When removing the filter element a valve is opened, the oil in the filter housing automatically flows into crankcase. t If the engine oil is drained and not extracted with an oil extractor, replace drain plug. This prevents leaks. t Observe disposal regulations! - Extract engine oil using used oil collection and extraction unit -V.A.G 1782-. or - Remove oil drain plug. - Let engine oil drain. > Note
t The oil drain plug is fitted with a secure seal, therefore the oil drain plug must always be renewed. t Observe disposal regulations! - Screw in new oil drain plug with seal hand-tight. - Replenish engine oil, specification ? Chapter. Engine oil capacity: "Power unit" ? Power unit; Rep. Gr.17"Lubrication; oil capacities" or ? Maintenance table. Specified torques for oil drain plug: t Petrol and diesel engines 30 Nm > WARNING
t Torque specifications must not be exceeded. t Excess torque can cause leaks in the area of the oil drain plug or even damage. Renewing oil filter Renewing oil filter, 1.4 l and 1.6 l injection engines > Note
t Prevent engine oil from dripping onto components in engine compartment. t Oil new O-rings before installing. t Observe disposal regulations! Renewing oil filter, 1.4 land 1.6 l engine Carry out the following procedure: alt="W00-10211"> - Unscrew cover cap -1- with socket insert 36 mm AF and remove cover with oil filter insert -4- and valve -5-. - Renew O-ring -2- of cover cap and O-ring -3- of valve. - Renew used oil filter element with new filter element. > Note
Observe disposal regulations! - Tighten cover cap -1-. Cover cap torque setting: 25 Nm. Replenishing engine oil Oil specifications ? Chapter Engine oil capacities: "Power unit" ? Power unit; Rep. Gr.17"Lubrication; oil capacities" or ? Maintenance table. General notes > Note
Observe disposal regulations! - After replenishing with oil, wait at least 3 minutes and then check oil level. - Pull out dipstick, wipe with a clean cloth and push dipstick in again to limit stop. - Pull dipstick out again and read oil level. alt="N01-10183"> For dipstick as illustrated: A - Oil must not be replenished. B - Oil may be replenished. It may happen that the oil level afterwards is in the -A- region. C - Oil must be replenished. It is sufficient if the oil level is in the -B- region (hatched area) afterwards. There is a danger of damaging the catalytic converter if the oil level is above the -A- marking. - If oil level is below -C- marking, top-up oil to -A- marking. alt="N01-10255">
25567142-tnzdbwhiaswbtdy3r1p2vgzs-2-2.png

Mar 14, 2015 | Volkswagen Polo Cars & Trucks

2 Answers

I need to know the following: fuel tank size( tank capacity),radiator capacity, oil capacity and oil pressure range for a 1987 Nissan Maxima


Fuel tank, 17.2 gallons. Radiator capacity, 1.25 gallons. Oil capacity 4.5 quarts with the filter. Oil pressure, 20-50 psi.

May 08, 2010 | 1987 Nissan Maxima

2 Answers

Just got an 1998 Isuzu Wizard (diesel), some times


It sounds like the fuel is gelled, is it cold where you are and what are running for fuel? If your in freezing weather you should be running blended fuel, straight No.2 will gel at about 25 degrees (F). Take a hair dryer or heat gun and warm the fuel filter up. Or if you can get in warm garage and get it started thin the diesel with kerosene, about 2 gallons to 20 gallons of diesel. Then drive it for at least five miles so the kerosene gets circulated through the system. I've used gasoline to do this too, but only use about 1 gallon to 20 gallons of diesel.

Jan 08, 2010 | 1998 Isuzu Trooper

Not finding what you are looking for?

5,383 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Loading...