Tip & How-To about 1995 Volkswagen Jetta

Water pump job

When replacing a water pump on a VW always replace the water pump bolts, use stanley steel if posible. The ones from the factory ussually break and are a pain to replace, sometimes you need to replace the water pump housing. VW has been doing great cars for a long time but they surprise you with this dumb mistakes of using low quality bolts in critical places like the water pump. Do they do it in purpose? may be...

Posted by on

1995 Volkswagen Jetta Logo

Related Topics:

Related Questions:

1 Answer

Cant get fuel lines off fuel pump


hi, are they connected thru pushfit and a jubilee clip to secure it and pipe has gone rigid thru time if this is the case boil kettle and pour boiling water onto pipe where it fits over nipple this should make pipe pliable allowing it to come off, some twisting is requred to break seal pipe has created to the fuel pump, if its fuel injection it has chance to be bolted on via the looped end and these always corrode together causing very stiff breaking of the connection, you can try applying wd-40 etc leave for hour then give some very gentle taps to each side of connection then possibly with someones help secure pump best you can to assist against the pressure your applying when trying to undo nut, pref always use hexagon socket not splined to prevent slipping and rounding of bolt heads, you can confidently apply required forcew to release bolts as these are hardened steel and very difficult to snap. hope this helps, let me know if i missed anything and to let me know results, kind regards
Paul.c

May 06, 2012 | Cars & Trucks

2 Answers

how do you remove the fan from 1998 f150 4.2 liter


how do you remove the fan and fan clutch from 1998 f150 4.2 liter engine. i am trying to replace the water pump but i cannot get the fan to break loose . i cannot figure how to stop pump from turning while trying to loosen the bolt or nut that holds the fan clutch on the water pump shaft . is there a special tool to help me with this

Jul 15, 2010 | 1998 Ford F150 Regular Cab

1 Answer

replace water pump in 96 vw jetta vr6


If you have the 2.0L motor than NO. You have to remove the timing belt to access some of the water pump bolts.

Dec 17, 2009 | 1996 Volkswagen Jetta

1 Answer

Water pump


Hello nedy...if you have the V6 engine, it will require the removal of the timing chain cover to access the water pump. The water pump is mounted to the engine block with 4 bolts. It is recommended that the bolts be replaced due to electrolysis (steel bolt in aluminum block) Replace all gaskets and o-ring seals as well.
While you are in there, you can inspect the timing chains, it has 3..and the chain tensioners. A Haynes repair manual would be helpful on this project and will have the correct torque specs.
Good luck...i hope this helps, please rate mr a fixya.

Jul 27, 2009 | Suzuki Grand Vitara Cars & Trucks

Not finding what you are looking for?

1,548 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Loading...