Tip & How-To about 2003 Chrysler Sebring

Door locking problem in a 03sebring

Hi my doors doesnt close automattically when car´s over 20Kmph, it happens since february, but local chrysler mechanics dont know what to do, they try a lot of thing, they told me to reprogarmm the central OBD, it´s necessary?

Posted by on

2003 Chrysler Sebring Logo

Related Topics:

Related Questions:

1 Answer

2005 Chrysler Town n Country. The electric tailgate opens OK but closes almost immediately with no activation. Happens on hills or flatl. it does not happen all the time, probably on 75% of openings.


Be sure nothing like a floor mat or tarp/blanket is over the "load to here" line marked at bottom of rear floor latch area. Also could be a micro switch going bad inside the power door operating mechanism. It has 2 of these. One lets it know when lift gate is fully open and the other shuts off motor and light on dash when fully closed and latched. A plastic sliding point rides the mechanism rail and pushes the micro switch. Or the micro switch has worn or dirty contacts inside of it making it work intermittently. Also the plastic slide point could be worn as to not push the switch in fully at contact. Not an easy fix. You have to remove the interior panels on right rear of vehicle and closely watch it operate to locate these switch points.

Nov 06, 2017 | Chrysler Cars & Trucks

1 Answer

My door locks close but they dont open


Switch may be dirty or worn out. Or the lock mechanisms themselves need to be cleaned and lubed. I would try cleaning the lock mecahnisms first.

Jan 28, 2012 | 1998 Toyota Corolla

1 Answer

The power lock (driver's side sliding door) on our 2003 Chrysler Town & Country Van will not work. We have to manually lock and unlock the door. How can this be fixed?


Take a look at end of door where latch is & post where the 2 meet when closed. Look for round metal button/contacts, about 1/2" in diameter. If you look close, they should line up to make contact with each other when door is closed. Take some fine steel wool (preferred) or fine sandpaper and scuff them up until you see metal is clean on both surfaces. Now try it, and let me know what happens.

Mar 06, 2009 | 2003 Chrysler Town & Country

1 Answer

hey how do u assemble a regulator in a car window


hi there if you remove the door skin to acess inside the door to get at the mechanics of the window locate the window motor and locate the 3 bolts that hold it to the frame,remove these you may want to put some foam blocks inside to hold window in position while removing regulator assembly attached to motor also remove positive battery terminal so you dont get injured due to window power grabbing your hand or fingers ok , replace the old regulator onto motor and reinstall and adjust so window closes all the way and not to much . good luck with this project let me know how this helped you by selecting the fixya rating .bye for now

Jul 04, 2008 | 1989 Chrysler Fifth Avenue

Not finding what you are looking for?

1,856 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Loading...