Tip & How-To about 2007 Audi A4 Convertible

Overriding Seat Belt Warning Tone

You don't need a vag comm nothing all you need to do is stick a toothpick in and push down that chrome metal piece till you hear the locking mechanism pop out. it pops out in the middle so you don't wanna push in from the middle rather then the edges. that will disable the warning tone and to enable it just release the belt

Posted by on

2007 Audi A4 Convertible Logo

Related Topics:

Related Questions:

1 Answer

A chrome piece (1 of 4) on the front grille broke off on my 2005 Kia Sportage. I need to remove the grille to get access to the screws that attach the chrome piece.


Hi there my name is Brandon I am a mechanical n electronic engineering technician I am the man reg mechanics call when they cant fix something it may have a spring you may have to push both side in to get it out some are a pain

Feb 02, 2016 | 2005 Kia Sportage 2.0

1 Answer

how dose the back seat come out


back seat don't need to come out if you were setting in back on each side near the windows the are to tabs near bottom of seat under the back of your knees where they bend. push in ******* the tabs try to lift seat up as tabs are pushed.will see metal plate like object with wire running through hold in metal piece. metal piece glued down pry up metal piece don't break wire that is hook on to your gas filter.

Jul 18, 2012 | 2000 Hyundai Accent

1 Answer

1997 Lincoln Town Car The drivers door lock is not working mechanically in automatic, something loose, I can hear it rattling inside the door when you us the remote. The rubber grommet that holds something in place that is located on lower left side is missing and I can see a small piece of metal and the rod to the lock moving when you work it manually. I have done nothing so far.


Hi all you need to do is take the door panel/card off and refit the rod it will push into a whole and it will be held in place by a push on clip, this clip will have more than likely fell into the bottom of the door, it will be a small black metal clip that goes around the rod and holds it into the lock at the other end.

this rod tends to fall off if the door has been slammed a few times of they can just work loose.

once you have the door panel off you will see what i mean about the small metal clip, this is an easy job to do and it only requires pushing the end of the rod into its place then put the metal clip over the top then your lock will be working again.

let me know if you need further assistance ok

plz rate this solution as i have a whole page of unrated posts, thanks

Aug 31, 2010 | 1997 Lincoln Town Car

2 Answers

car won't start and dash light flickers


Sounds like bad connection at battery. Remove the battery connections, clean the battery posts with a wire brush, and reconnect battery. Make sure connections are tight.

Jun 03, 2009 | 1999 Acura TL

Not finding what you are looking for?

1,232 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14381 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Loading...