Tip & How-To about Acura CL

How to reset the service/spanner interval light on vauxhall holdon opel

1 foot on brake
2 finger on milage trip switch
3 turn key till dash lights come on
4 hold for about 3mins or intill light flashes and goes out
5 key to off position
6 foot of pedal
7 finger of button
8 key to lights on position
9 light should go out
10 if light is not out try steps again with foot on clutch as well as brake
hope this has saved you money!!!! (maindealers are expensive)
thanks jezza

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

On a 2008 Lexus LS350 the oil light was not reset after an oil change. It does not have a key. I tried using the "hold tripodometer and pressing he start button with my foot off the brake" - no good!


Turn ignition on, press trip button till you see trip A. Turn ignition off, press the trip button and turn the ignition on while you hold the trip button, once the 5 dashes flash away it will reset.

Nov 17, 2009 | 2008 Lexus Rx 350

2 Answers

Maintenance Lamp


Here's how you reset your maintenance light.

To reset the light,
Turn the ignition on
Make sure the odometer displays "ODO"
1.Turn the key off
2.Press and hold down the same button you use to get to "ODO"
3.Turn the key back to ON ( while still holding down the button)
4.Hold the button in until all the flashing lines on the odometer go away and the bunch of "000000" shows up and the maint reset light will turn off.
Your'e done.

If this doesn't work, you would have to try it on "trip A" instead of "ODO".

Oct 03, 2009 | 2006 Toyota Tundra

1 Answer

clearing service message on dash


Turn the ignition to position 1 Push and hold trip reset while holding. Turn to position 2 hold trip reset till the service light flashes 3 times and then release. You should hear a beep to let you know it is reset. It might take you 2 times sometimes. If you have the message in the text window the little triangle in the center of the speedo assy. will flash. Also another trick to help you is when the milage returns the light should be reset.

Jan 22, 2009 | 2004 Volvo S60

2 Answers

how do I turn off the change oil light on a 1994 corvette


1. Turn the key to “Run,” but don’t start
2. Press “ENG MET” on the Trip
the engine.
Monitor. Then, within five seconds,
press it again.
3. Within five seconds, press and hold
“GAUGES” on the Trip Monitor. The
“CHANGE OIL” light should flash.
4. Hold the “GAUGES” button until the
“CHANGE OIL” light stops flashing
and goes out. This should take about
ten seconds.
When the light goes out, the monitoirs
reset. If the monitor doesn’tr eset, turn the
ignition off, then try again.

Nov 18, 2008 | 1994 Chevrolet Corvette

Not finding what you are looking for?

1,072 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Loading...