Tip & How-To about Toyota Camry

Where is the turn signal relay located on a toyota camry

If your trying to locate the turn signal relay than what you need to do is open the glove box up and then remove the glove box completely.
The actual relay is then located at the top of the glove box, its listed as block number 6 in the actual workshop manual so once you have the glove box out you should be able to see the relay towards where the top of the fuse box was.

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

Location of turn signal relay 1981 Dodge 250 van


I think its in the near the fuse box, on mine I have to remove the glove box liner to access it, its a small round thing with either 2 or 3 prongs on it

Sep 23, 2016 | Dodge Cars & Trucks

1 Answer

location of signal flasher module in 2004 blazer


Hazard and Turn Signal Flasher Replacement
Open the glove box to expose the glove box retaining tab (1). Lift the retaining tab and allow the glove box to hang freely.
Using a suitable flat-bladed tool, release the plastic retainer that retains the hazard/ turn signal flasher (1) to the C203 body harness connector (2) . Remove the hazard/ turn signal flasher (1).

Jun 12, 2015 | 2004 Chevrolet Blazer

2 Answers

i need help locating turn signal flasher


Turn signal flasher is normaly located in the fuse panel. It should be round and have three prongs If I remember right. there might be two of them, one for signal and one for hazard.

Jan 01, 2011 | 1997 Chevrolet S-10 Pickup

1 Answer

where is the turn signal flasher located on a 2002 vw jetta?


Hi,

It is located in the relay box behind the lower dash under the steering wheel, in alignment with drivers right knee. (right hand drive) You have to remove the screws that hold the panel on and take panel right off. If you remove fuse box cover, look behind and you can see them. Fuse box cover is on the end of the dash board. Hope this helps

I'm answering my own question here. It's located behind the hazard lights switch. You have to pop out the old one with a flathead screw driver. Remove it and simply place the new one on. You might need some needle nose plires to pull the actual relay out and also to pull out the connecting end. You might have to play with it for a lil while but it should come completely out. If you still have a hard time just take out the glove box and reach around the tight spots until you reel for thr cords on the connecting end. I did all this in about 30 minutes and saved a lil over 100 dollars. The relay itself cost about 26 dollars at the vw dealership.

Oct 29, 2010 | 2002 Volkswagen Jetta TDI

5 Answers

Turn Signal Flasher location in 93 Mustang GT


The flasher is a small round plastic cylinder (unless replaced with a metal one) behind the left edge of the glove box that will look similar to the one in the fuse panel. The first step is to squeeze gently both sides of the open glove box and let it swing downward. It will be snapped into a metal horizontal brace just to the left of the glovebox opening by a small tab and have two wires attached. The number more than likely will be a #552 although I have seen a factory one with a Warner #224

Feb 11, 2009 | 1993 Ford Mustang

Not finding what you are looking for?

2,095 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Loading...