Tip & How-To about Ford Edge

Replacement of burnt out rear brake lights on a Ford Edge model years 2011 through 2014

The 2011 through 2014 Ford Edge has two lights for the rear brake light system. This is how you change burnt out brake light bulbs. 2011 Ford Edge tail light bulb replacement

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

No brake lights


If the fuses, bulbs, switch are good then its your wiring, you have a break somewhere, check the switch behind your brake pedal, make sure you have power to the light sockets and they are not burnt, my wife has a ford edge and burnt right rear socket and the light still worked, go figure, anyways good luck

Apr 04, 2014 | 2000 Ford Expedition

1 Answer

how do i change the break light bulb


TO CHANGE BRAKE LIGHT BULB YOU WILL HAVE TO OPEN THE TRUNK, PULL BACK THE CARPET WHERE THE REAR TAILLIGHTS ARE AND UNSCREW THE SCREWS THAT HOLD IN THE LIGHT, ONLY THEN CAN YOU CHANGE THE BULB THAT IS BURNT

Jan 28, 2011 | 2000 Ford Focus

1 Answer

change out a taillight


You want to change the tail light bulb?

The process for replacing tail light bulbs is the same in all models. If you have a burnt-out tail light bulb, you may need to replace the brake light, the reverse light or the turn signal. The procedure to replace each of the bulbs is the same.



    Instructions

    1. Open the Hummer's rear swing gate. This will expose the edge of the vehicle's tail light assembly. You'll see two small Phillips head screws that hold the tail light assembly in place. Put on your gloves.

    2. Remove the two screws from the tail light assembly. Pull the tail light out and inspect the back for two bulbs. The top bulb is the brake light and turn signal. The bottom bulb is the reverse bulb. Determine which bulb you need to replace.

    3Rotate the bulb's socket counterclockwise to disconnect it. Unplug the bulb from its socket.

    4Push the replacement bulb into its socket firmly. Insert the socket back into the tail light. Turn it clockwise to secure it in place.

    5Place the tail light into its cradle. Hold it with one hand and replace the Phillips head screws with the other.

Dec 03, 2010 | 2008 Hummer H3

1 Answer

2001 ford f150. blinkers want work. brake lights want work. but the light at rear above back glass works when i press the brakes. help


you need first to determine the obvious as most people don't check to see if there brake lights work. make sure the bulbs are not burnt out. if you use the blinkers and the light stays on when you operate them that is usually an indication a light is burnt out.

Aug 16, 2010 | Ford F-150 Cars & Trucks

1 Answer

2007 Ford Edge: Rear Blinkers/Brake Lights out; Not bulbs or fuse


Sounds like you need bulbs on both rear side lights. Does the blinker flassh really fast?

Feb 25, 2010 | 2007 Ford Edge SEL Plus

Not finding what you are looking for?

753 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5572 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Loading...