Tip & How-To about Ford Cars & Trucks

Ford Edge Transmission Torque Mount diagnosis

Diagnosis on the Ford Edge to see if the transmission needs replacement. In this video the transmission torque mount is still in great condition after logging 134, 000 miles on this 2011 Ford Edge.
Testing the condition of the transmission torque mount on 2011 Ford Edge

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

2 Answers

I just had a torque converter replaced because of a loud whining noise. After i picked up my ford f150 (2004) i noticed a bad vibration just sitting still. I had new plugs put in, but still have vibration ( no engine light ever came on) i called transmission guy back and he said sometimes these converters get out of balance. Have you heard of this?


Absolutely heard of and seen out of balance torque converters do exactly as you are describing. Since you just had it replaced before you picked up on the vibration that is the first place I would look.
Let us know how it goes with the transmission shop?

Mar 31, 2015 | 2004 Ford F150

1 Answer

How to fix p1744 on 2001 ford expedition


This code has to with the TCC - Torque converter clutch
P1744 TCC TCC The PCM picked up an excessive amount of TCC slippage during normal vehicle operation. TCC slippage/erratic or no torque converter clutch operation. Refer to Diagnosis By Symptom in this section. You'll need to pull the transmission out an replace the torque converter ! Your better off taking to transmission shop an having a proper diagnosis done !

Feb 18, 2015 | 2001 Ford Expedition

1 Answer

My 1995 F350 Powerstroke "Shutters"


VIBRATION - DRIVELINE RESONANCE/VIBRATIONBETWEEN 1400 AND 2000 RPM WITH CONVERTER
Clutch ENGAGED DURING MEDIUM TO HEAVY
THROTTLE CONDITIONS - VEHICLES WITH 7.3L DI
TURBO ENGINE AND TRANSMISSION BUILT PRIOR
TO 11/13/95 (5L13)
^ TRANSMISSION - E40D - DRIVELINERESONANCE/VIBRATION BETWEEN 1400 AND 2000
RPM WITH CONVERTER
Clutch ENGAGED
DURING MEDIUM TO HEAVY THROTTLE
CONDITIONS - VEHICLES WITH 7.3L DI TURBO
ENGINE AND TRANSMISSION BUILT PRIOR TO
11/13/95 (5L13)

FORD:
1995-1996 E-350, F-250 CREW CAB, F-350 CREW CAB
Article 96-26-21 is being republished in its entirety as part of a consolidated 7.3L diagnostic aid booklet.
ISSUE
Some vehicles with transmissions built prior to 11/13/95 (5L13) may exhibit a driveline resonance/vibration between 1400 and 2000 RPM with the torque convertor engaged. This may be caused by the torque converter.
ACTION
Prior to torque converter replacement, refer to the following Service Procedure for details to verify conditions.
SERVICE PROCEDURE
1. Verify the resonance/vibration does not occur in neutral and is most noticeable between 1400 and 2000 RPM with the converter clutch engaged during medium to heavy throttle conditions. Also watch for the vibration to diminish at engine speeds lower than 1400 and higher than 2000 RPM. If the concern meets all of these conditions and the transmission has a built date prior to 11/13/95 (5L13), replace the torque converter. Refer to the appropriate Service Manual for removal and installation procedures.
2. If the vibration concerns do not meet the conditions, check for non-factory installed items that could affect driveline and verify proper installation. Also refer to the appropriate Service Manual, Section 05-00 for diagnosis and testing.
107118085

Aug 22, 2011 | 1995 Ford F250

2 Answers

ford trauras trouble code 732 - was told transmission code 732 was being produced, what does a code 732 say?


P0732 FORD - Incorrect Second Gear Ratio
Transmission in second gear and the ECM detected an incorrect gear ration. This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:

Torque converter slip ratio = A x C/B

A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes

If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Incorrect transmission shifting

Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Shift solenoids
- Transmission mechanical problems
- Transmission hydraulic control circuit

Tech notes
Start by inspecting the transmission fluid level and condition, and change fluid if necessary.


Hope helps.

Apr 26, 2011 | Ford Taurus X Cars & Trucks

Not finding what you are looking for?

1,000 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Loading...