Tip & How-To about 2008 Chevrolet Cobalt

Back up light switch location

Easiest access may be by removing the left wheel. It's right there in back left of trans axle.

Posted by on

Cars & Trucks Logo

Related Topics:

Related Questions:

1 Answer

2001 ford windstar the right axle spin slower then the left one. What can be the problem i both two new axle and it stil spin slower then the right but it move better do i need to rebuild the trans


I don't think you can assess the condition of the transaxle by spinning the wheels.
The differential in the transaxle converts power from the transmission to the wheels by a set of gears. It would almost impossible for one side to turn at a different speed than the other.
You may have more drag on the brakes on one wheel, or the fluid in the transaxle could cause one side to go slower with the van off the ground.

Jul 05, 2012 | 2001 Ford Windstar

2 Answers

Do u have to remove the transmission too get to the drive axle? Or what do i need too do.I'm inquiring about a 2002 ford.I have a new CVShaft and new wheel bearing for the front passenger side.


no you don't need to remove the tranny to remove the drive axle. All you need to do is first remove the wheel, then remove the brake assembly, then remove the rotor , then remove the axle nut, then remove the lower ball joint then remove the drive axle. do the steps in reverse to assemble.

Mar 04, 2011 | 2001 Ford Windstar

1 Answer

How do I change the front passenger CV joint?


Easiest approach is to change entire axle. Depends on car, but generally remove wheel, remove axle nut, loosen lower ball joint and separate wheel assy from a-frame. In some cases, tie rod end must be taken loose. Wheel bearing assembly must now be pulled out swinging about the strut to allow axel spindle to come out of the bearing. Once axle is out of the bearing, place a drip pan under the trans and pull the axle out of the trans. Reverse procedure to reinstall.

Aug 23, 2010 | Ford Ranger Cars & Trucks

2 Answers

installing an automatic transmission into a front wheel drive


Put it on a lift,support the engine from up top or under it, if you don't plan on using the lift for another job. Pull the axles. Then drop one side of the engine/suspension cradle,then the trans.

Mar 19, 2010 | 1992 Oldsmobile Cutlass Ciera

Not finding what you are looking for?

1,286 people viewed this tip

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Loading...