where is the inside fuse box location on a v6 2000 camry- not in the obvious places-
Posted by camaro68 on
It locates behind the coin box ( left , below steering whell ). You have to replace the coin box, just pull it out sofly. =)
Posted on Jul 06, 2008
where is cabin air filter located and how to replace it?
Posted by Zaf Zaf on
its is behind your glovebox
Posted on Dec 12, 2012
Need to change tthe fuel filter on my 2002 Toyota Camry.
Posted by slugabug13 on
Where is the fuel filter located on a 2002 Toyota Camry
Posted on Oct 11, 2012
I have 2000 camry and i went to autozone and they said i have a code p0300 and i was wondering what could be the problem.
Posted by mamapitbul... on
Basically this means that the car's computer has detected that not all of the engine's cylinders are firing properly.
A P0300 OBD DTC code indicates a random or multiple misfire. If the last digit is a number other than zero, it corresponds to the cylinder number that is misfiring. A P0302 code, for example, would tell you cylinder number two is misfiring. Unfortunately, a P0300 doesn't tell you specifically which cylinder(s) is/are mis-firing, nor why.
A code P0300 may mean that one or more of the following has happened:
If there are no symptoms, the simplest thing to do is to reset the code and see if it comes back.
If there are symptoms such as the engine is stumbling or hesitating, check all wiring and connectors that lead to the cylinders (i.e. spark plugs). Depending on how long the ignition components have been in the car, it may be a good idea to replace them as part of your regular maintenance schedule. I would suggest spark plugs, spark plug wires, distributor cap, and rotor (if applicable). Otherwise, check the coils (a.k.a. coil packs). In some cases, the catalytic converter has gone bad. If you smell rotten eggs in the exhaust, your cat converter needs to be replaced. I've also heard in other cases the problems were faulty fuel injectors.
Random misfires that jump around from one cylinder to another (read: P030x codes) also will set a P0300 code. The underlying cause is often a lean fuel condition, which may be due to a vacuum leak in the intake manifold or unmetered air gettingpast the airflow sensor, or an EGR valve that is stuck open.
Posted on Mar 23, 2009
I have a 2000 Camry. The clock and the cigarette lighter quit working. The manual doesn't have any diagrams for fuses. Which one should I check?
Posted by ginben1 on
The fuses are located behind the ash tray... pull it out and look on the back of the ash tray...may have a diagram on the back of the tray... let me know how you do.
Posted on May 10, 2009
replace thermostat in a 2000 toyota camry
Posted by cramnedsac on
Drain radiator by opening drain plug. Undo clamp and remove radiator hose from front of engine near oil filter. Undo bolts holding the thermostat housing. Replace. Be sure to use new O-ring. Re-attach the hose. Refill the radiator through the cap. Idle and check for leaks. Cool down and check coolant level.
Posted on Feb 24, 2010
2000 toyota camry turn signals not working. Fuses check out and bulbs good.
Posted by ospotts on
Hi, i recommend testing the switch and flasher module. i will post the testing procedures for both devices. replace the device that is faulty.
To test turn signal switches, use a 12-volt test light to probe for voltage into and out of the switch. The ignition switch must be in the RUN position for the circuit to operate. If voltage is present on the input side of the switch but not on the output side, the switch is faulty.
FLASHER TEST PROCEDURE---
If the turn signals operate properly in one direction but do not flash in the other, the problem is not in the flasher unit. A burned-out lamp filament will not cause enough current to flow to heat the bimetallic strip sufficiently to cause it to open. Thus the lights do not flash. Locate the faulty bulb and replace it.
Posted on May 19, 2009
I want to replace my radiator , what are the steps to do it right.
Posted by pontiacgto... on
Let the engine cool down. With a catch can under the radiator unscrew the petcock. It's usually on the bottom drivers side end tank. Next disconnect the fan wiring and remove the fans. Disconnect the upper and lower radiator hoses and the overflow hoses from the radiator. Remove the two transmission cooler lines. Remove the two mounting brackets at the top of the radiator and pull the radiator out. Transfer any parts that aren't included with the new radiator and install radiator. The rest is the reverse of removal. I like to use new hose clamps and fresh antifreeze whenever i change a radiator, but it's up to you. If the original antifreeze isn't too old and you didn't get any transmission fluid in it you could reuse it you want.
Posted on Nov 21, 2009
Where is the relay for fuel pump 2000 Toyota camery 2.2ltr
Posted by jason... on
It is located in engine fuse box, and is marked C/O (circuit open relay) this is your fuel pump relay, good luck.
Posted on Jul 06, 2012
how do I locate and change a thermostat in a 2000 toyota camry
Posted by jim8464 on
This is better done when your engine is cold.
Park the car on a level fround.
Open the hood and remove the radiator cap.
Put a sizable container under the radiator and open its drain-plug.
(the drain-plug is by the radiator lower back wall).
Thermostat is in the inlet pipe held by three 10mm bolts that's attached to the engine block. (please note how it sitted)
Installation is reverse of removal. (replace o-ring around thermostat with a new one)
Posted on Nov 13, 2009
1,662 questions posted
Usually answered in minutes!