20 Most Recent
1989 Toyota 4Runner Questions & Answers
Where will I find the
There is no mark. Toyota makes use of 2 different colored links on the timing chain. Get the no 1 cylinder on TDC. Align one of the 2 different colored links on the chain with the mark on the crankshaft cog. Aligh the other different colored link with the mark on the camshaft.
89 TOYOTA HILUX 22R PETROL 2 WHEEL . WHAT ARE
Toyota Pick-ups/Land Cruiser/4Runner 1989-1996
Timing Belt
Fig.: After rotating the engine, ALL the timing marks must align perfectly
NOTE: Mark the position of the belt if it is to be reused
Toyota Pick-ups/Land Cruiser/4Runner 1989-1996
Timing Chain
- 22R and 22R-E Engines
Fig.: Exploded view of the 2RZ-FE and 3RZ-FE engine timing chain componentsFig.: Align the small timing mark of the balance shaft drive gear with the timing mark of the balance shaft timing gearFig.: Align the timing marks as shownFig.: Exploded view of the timing chain and cover on the 22R and 22R-E enginesHope helps.
I turn the key and nothin happens no noise doesnt turn over
The most common cause of a non-starting car is the battery. It is either weak, (low voltage) dead, (zero voltage) or has bad connections. (corroded or loose) I will assume you have a fully charged battery with good connections. (both to battery and starter relay)
If you remove the starter switch lead (small wire) from the starter relay and apply +12v from the battery to its respective prong or lead on the relay, and your starter cranks, your starter switch is faulty. (not to be confused with your key switch). If you jump the two large wires together on the relay and it cranks, then the relay is faulty. If you jump the two large wires together and nothing happens, then starter is faulty, or wires to starter are loose or broken. Picture of starter switch prong on the relay is pictured. NOTE: sparks are to be expected, so don't be too scared.
How to remove glow plug fuse from holder
there are two 10mm nuts securing the fuse box, remove those and then push the 80amp fuse downwards out of the fuse box (you'll see a clip to the side of the 80amp fuse) once you've slid it out from the bottom of the fuse box you'll see it the wire terminals bolted to the fuse. undo the 10mm nuts and remove. easy as!
Not finding what you are looking for?