http://www.fixya.com/cars/p700354-toyota_1986_pickup_4wdSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comMon, 09 Nov 2009 05:57:43 GMT80http://www.fixya.com/support/t3357300-1986_toyota_p_u_22r_vacuum_lines_hookengine wont start unless you spray starting fluid into carb. then runs short time.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3344605-toyota_1986_trucks_blower_suddenlyMy Toyota 1986 truck's blower suddenly stopped working. I checked the fuses. Are there any fuse splices or something I'm missing? What other likely parts are to be at fault? Thanks.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3297104-86_toyota_4x4_22r_motorI have an 86 toyota 4x4 with the 22r motor. my problem is the blower motor only works on the highest 2 settings for the fan. Is their a relay that is bad? why doesn't it work on all 4 positions like it should?Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3266056-change_gear_slave_cyilinder_toyota_4I need to change the gear slave cyilinder on a Toyota 4 runner 1986. How do i do it?Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3210317-86_toy_4x4_u_put_in_5th_gear_holdmy 86 toy 4x4 if u put it in 5th gear and hold it in it will stay but if u dont it pops in neutral ive been told its ashifter seat bushing. is that true?Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3183285-no_power_going_up_hillsMy 1986 Toyota Pick-up 4X4 has a 4 cyl motor with 30K miles since it was rebuilt. It also has an automatic transmission. It has no power going up hills and the transmission shifts back and forth between gears.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3181059-changed_starter_but_still_clicking_fusechanged starter but still clicking by the fuse boxMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3111607-much_oil_2001_serria_c3_pick_up_truckhow much oil does an 2001 Serria c3 pick up truck need.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3145743-93_toyota_4wd_makes_loud_noise_when_pushsounds like a loud bad belt. it still pulled fine in all gears but a mechanic said it was the transmission...what do you think? thank youMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3099880-set_timing_1986_toyotawhat do I set the timing to, on a 1986 Toyota carburated 22r? I've seen all sorts of numbers, 0, 5, 12 degree BTDC.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3093786-rough_idle_hesatates_about_half_throttlerough idle and hesatates about half throttleMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3075993-gort007_done_c_clamp_thingGort007, I have done the C-clamp thing and installed the new brakes- reassembled them- when I apply the brakes the caliper extends and stops the wheel. I let off the brakes and the caliper does not return to free the rotor to turn. Where else do I...Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3074924-86_toyota_p_u_disc_brakes_2_wheel86 Toyota P/U disc brakes,22R engine, manual trans, 2 wheel drive..what returns the caliper piston to rest when I release the brakes. What else do I need to look at and or rebuild to get them to release? Thanks JimMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3074626-pcv_valve_gowhere does pcv valve goMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3066762-find_fuel_filtercant find the fuel filterMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t3048527-rebuilt_carburator_new_feul_pump_feulrebuilt carburator new feul pump feul line seems to have no vacuum coming from aap could this make it sluggish idles fine when you take off seems sluggiish and what is a tsvsMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2994397-plug_gap_86_toyotaHello. what should the plug gap be on a 86 Toyota with an 22R series motor. I am using an Autolite plug.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2991675-truck_wating_alot_gasmy 86 toyota 4wd truck is wasting alot of gas!Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2125411-find_fuse_panel_diagram_1986Where can find a fuse panel diagram for a 1986 4x4 toyota pickup truckMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2520811-22r_carb_dumping_fuel_2500_rpm_will_not22r carb dumping fuel at 2500 rpm will not pass smog.Was rebuilt and is in smog specs. at idle.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2963512-turns_over_but_doesnt_startturns over and drives but dies when i let off gas and wont start back up.Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2971562-toyota_truck_missing_2_cylindersmy toyota truck is missing on 2 cylinders it has full comp. wires and plugs are good any ideasMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2860817-1986_toyota_pickup_parking_brake_cable1986 Toyota pickup. Parking brake cable snapped inside barrel (at handle). How do I remove and replace?Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2860504-sometimes_get_engine_turn_oversometimes i can't get the engine to turn over, nothing happens when i turn the key. battery is good,Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2860563-torque_specs_1986_toyota_pickupWhat are the torque specs for a 1986 toyota pickup?Mon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t996594-1986_toyota_pickup_stereo_wiring_colorToyota stereo color codes FOR 1986 PICKUP to a pioneer stereo if u can please thankyouMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2838497-took_apart_throttle_cable_mountingi took apart my throttle cable and mounting bracket to replace the intake manifold gasket, and one of the pieces came apart from the rest, i'm not sure how to piece it back togetherMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t2837808-water_in_oil_not_running_hot_or_skippingwater in oil not running hot or skippingMon, 09 Nov 2009 05:57:43 GMThttp://www.fixya.com/support/t1918524-new_clutch_slips_when_hotI have a 1986 Toyota pickup, had the clutch replaced about 2,000 miles ago. If I tow or use 4WD, and get my clutch hot, it slips. If I let it cool 10 minutes or so, it seems to do alright. Is it possible the mechanic didn't have the plate resurfaced...Mon, 09 Nov 2009 05:57:43 GMT