Top 10 1992 Lincoln Town Car Questions & Answers

did you check your brake fluid and if its not that the anti-lock light by itself wont hurt the car but the brake light coming on check your brake line hoses and see it they have ony holes in it also check out your brake resvoir and then your master cylinder all of your brake systems is connected together

the fuse and relay are located in the battery fuse box under the hood, just in back of the battery and the fuse and relay locaters are printed under the lid.

try this i have a 93 Lincoln Town car and the air suspension light was on this is what i did there is a fuse under the hood that is for the air suspension the fuse was loose i took the postive side of the battery off and took some needle nose plier because the fuse holder was loose and made the fuse so it was not loose also took some electronic cleaner and clean the plug in back under the car wish you the best of luck Michigan man.

passenger side of engine firewall at base of firewall, you must go under the car to see it.

this is the oldest info I have. should be similar

Section 11-05: Steering Column Switches 1994 Town Car, Crown Victoria/Grand Marquis. Workshop Manual
REMOVAL AND INSTALLATION Ignition Switch Removal

1. Disconnect battery ground cable. Remove the upper steering column shroud by removing the four or five self-tapping screws. Remove tilt steering column lock lever (if so equipped).

1. Remove lower steering column shroud.

1. Disconnect the ignition switch electrical connector.

1. Rotate ignition switch lock cylinder to the RUN position.

1. Remove the two screws retaining ignition switch.

1. Disengage the ignition switch from the actuator.

Installation
NOTE: A new replacement ignition switch assembly will be set in the RUN position as received.

1. Adjust the ignition switch by sliding the carrier to the ignition switch RUN position.

1. Check to ensure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90 degrees from the LOCK position.

1. Install the ignition switch into the actuator. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing threaded holes.

1. Install retaining screws. Tighten to 5.6-7.9 Nm (50-69 lb-in).

1. Connect electrical connector to ignition switch.

1. Connect battery ground cable. Check ignition switch for proper function, including START and ACC positions. Also, make certain that the column is in the LOCK position.

1. Install upper steering column shroud.

1. Install the lower steering column shroud and tilt steering column lock lever (if so equipped).

First disconnect battery. Use a floor jack to lift vehcile from passenger side. Use floor jack to help hold up car for safety. The starter will be located ton the passenger side. It is held by two bolts. There will be one wire to a 10 mm nut. remove. There will be a couple of wires in cluding one from the baterry to a big bolt remove the nut. Remove the two bolts being careful as starter may drop. You can use the floor jack to help you since the floor jack is suppporting the vehicle. Reinstall in reverse.

Could just be a dead battery

This is not a repair shop or free tech support site,
just a social web site like facebook

Power from 15A fuse 1 in the I/P fuse panel is applied to the trunk lid pulldown motor/switch assembly.

Have you tried unlocking and locking the drivers door using the key. This will usually reset the alarm system

92-94 Lincoln Town Car Fuse Box Diagram - Auto Fuse Box ...

www.autofuseboxdiagram.com/8895-92-94-lincoln-town-car-fuse-box-...
Sep 11, 2012 - 92 94 Lincoln Town Car Fuse Box Map 276x300 92 94 Lincoln Town Car Fuse Box 92-94 Lincoln Town Car Fuse Box Map. Fuse Panel Layout ...