last wednesday while out on the back roads, i decided it would be a good time to run thru my 4 wheel...
(More)
LAST WEDNESDAY WHILE OUT ON THE BACK ROADS, I DECIDED IT WOULD BE A GOOD TIME TO RUN THRU MY 4 WHEEL DRIVE (ELECTRONIC 2H, 4H, 4L, & ALL WHEEL), ALL OF THE SHIFTS WENT FINE, AND I THEN DROVE HOME. IN THE MORNING HOWEVER THE JIMMY WOULD NOT GO INTO REVERSE AND DID NOT HAVE DRIVE 3 OR DRIVE 2, ONLY LOW 1 TO DRIVE. I THEN HAD IT LOCK UP IN FOUR LOW AFTER I WAS CYCLING THRU THE 4 WHEEL DRIVE AGAIN TRYING TO REGAIN REVERSE, AFTER FINALLY GETTING IT OUT OF 4 LOW AND BACK INTO 2H (STILL NO REVERSE) I THEN PROCEDED TO PUT THE TRANFER CASE INTO NUETRAL BY HOLDING THE THE 2H BUTTON AND THE 4L BUTTON UNTIL THE TRANSFER CASE SHIFTED TO NEUTRAL. I THEN PUT IN REVERSE AND THEN TO DRIVE AND LOW AND BEHOLD DRIVE STILL ENGAGED WITH THE TRANSFER STILL IN NEUTRAL, I HAVE CONTINUE TO DRIVE IT IN DRIVE 1 TO DRIVE AND HAVE BEEN TAKING IT VERY EASY HOPING THAT WHAT EVER HAS STUCK SERVO WISE WILL LOSEN IT SELF AND COME BACK ON LINE. NOW KEEP IN MIND I HAVE NOT BEATEN THIS VEHICLE, NOR DID I GET IT STUCK AND HAMMER IT BACK AND FORTH BETWEEN DRIVE AND REVERSE, I MEARLY WAS SHIFTING THRU THE 4 WHEEL DRIVE, ANYONE WITH INSITE INTO THIS, YOUR HELP WOULD BE GREATLY APPRECIATED
2000 Jimmy stuck in 4 wheel high. Replaced encoder motor, was stuck in 4 wheel low but now just...
(More)
2000 Jimmy stuck in 4 wheel high. Replaced encoder motor, was stuck in 4 wheel low but now just high.
i have a 2000 jimmy 4x4 with the 4.3L my problem is with the abs light it came on and now it justs...
(More)
i have a 2000 jimmy 4x4 with the 4.3L my problem is with the abs light it came on and now it justs stays on.The breaks seem to work just fine.I ran a computer test on it and it came back with all systems pass.What could be the problem??
jimmy 4 wheel drive won't go into 4 wheel drive high when button is pushed but sometimes goes into 4...
(More)
jimmy 4 wheel drive won't go into 4 wheel drive high when button is pushed but sometimes goes into 4 wheel drive low on it's own especially after being in reverse
need to find BTSI switch on a 2000 GMC jimmy w/4.3L engine and 4L60E transmission.shifter is on the...
(More)
need to find BTSI switch on a 2000 GMC jimmy w/4.3L engine and 4L60E transmission.shifter is on the floor or console.
i have changed my fuel filter, my fuel pump, and fuel is getting to the injectors, and i have...
(More)
i have changed my fuel filter, my fuel pump, and fuel is getting to the injectors, and i have spark...but the truck will still not start
My 2000 GMC Jimmy recently developed a series of problems. First, the key could not be removed after...
(More)
My 2000 GMC Jimmy recently developed a series of problems. First, the key could not be removed after shutting off the engine. I found the key release under the ignition switch to resolve that issue. Then the alternator failed. After replacing the alternator all was fine for a day then starting became a problem. When starting, battery voltage is good, but it acts like a bad terminal or starter connection. Connections were found to be okay. There is a lot of electrical noise and the starter turns slowly. Also, various lights come on in the dash, the tailgate window releases and the tow/haul light comes on. Sometimes the "security light stays on while driving and the driving lights sometimes do not come on. Any solutions?
2000 jimmy 4.3 v6 when started cold in the morning it has no power for about 30 seconds it falls on...
(More)
2000 jimmy 4.3 v6 when started cold in the morning it has no power for about 30 seconds it falls on its face when you try to accellerate then it takes off fine.when hot and parked for 20 minutes it does the same thing.it has been doing this for 2 years now and its getting worse.fuel filter did not make a differnce and it has 60 psi fuel at the rail.