Ford 1990 EconolineTroubleshooting & Support

Problems & Solutions

Solved Problems for 1990 Econoline - White-on-White RSS Feed

I have a 1990 Ford E350 van. I replaced the head

YEP FUSE LINK COULD BE THE PROBLEM LOOK FOR A 18 GAUGE WIRE FUSE LINK LOCATED NEAR THE AIR CONDITIONING CASE. THIS FUSE LINK CONTROL POWER...
- James24977
- Dec 3, 2010
- 79 Views
- 1 Solution
Replacing rear drum brakes.

REMOVAL & INSTALLATION Light Duty Systems Fig. 1: Light duty brake system components Raise and support the vehicle and remove the wheel...
- michaelstill
- Oct 9, 2010
- 435 Views
- 1 Solution
After sitting, hard to start

OPERATION The Idle Air Control (IAC) valve controls the engine idle speed and dashpot functions. The valve is located on the throttle body...
- john hardy
- Aug 1, 2010
- 424 Views
- 1 Solution
Where do I put the re charege into the system on a

i take it your are talking about your air conditiong ?
- Guest
- Jun 23, 2010
- 99 Views
- 1 Solution
Fleetwood Flair 460 ford econoline chassis. Radio

Have you pulled the stereo out to see if it had an external fuse in the back of it? Is this a stock stereo, or is it an aftermarket? Thanks,...
- warrendale10
- Jun 22, 2010
- 160 Views
- 1 Solution
The van E150 Ford Idles too high from the I start

its ur 'auto choke', its supposed to run a little high at first while it warms up, but if its too high u may have a faulty unit.
- Howard Alexander
- Jun 18, 2010
- 277 Views
- 2 Solutions
When the 1990 Ford van is switched to the front

When you switch tanks can you see what the correct amount of gas is in the that forward tank? Can you verify that the fuel-pump inside the...
- davidwmccall
- May 19, 2010
- 163 Views
- 1 Solution
I dropped the fuel tank to drain old gas.I put new

Turn the key to the ON position without starting the engine. You should hear the fuel pump running for 5 seconds if working. This primes the...
- mcpcarpenter
- May 8, 2010
- 139 Views
- 1 Solution
where is the distributor area on a ford econoline

This is on the distributor,the distributor is in the front,and has plug wires going to the distributor cap on top of the distributor.Look in...
- micalili
- May 3, 2010
- 74 Views
- 3 Solutions
lost power andquit. wont start

2 possible problems here. remember to always look at the inexpensive first. That would be the ignition control module,which is held on by 2...
- micalili
- May 1, 2010
- 126 Views
- 1 Solution
hood latch release inside cable will not realease

The cables and latch become dirty and corroded,and the spring wrapped cabbles can even rust on the inside. The cable itself may have broke....
- actionemusic
- Apr 29, 2010
- 112 Views
- 1 Solution
truck turn off after 5 minutes

Could be clogged fuel filter that's in fuel line on frame back by the fuel tank.Also could be bad fuel pump.Lose fuel pressure when it...
- maria_chapal
- Mar 19, 2010
- 49 Views
- 1 Solution
e-150 fuel pump inertia switch location

on some fords it is on pass side kick panel you have to feel in a hole and you will feel a reset button,hope this helps
- jpelectric1
- Feb 13, 2010
- 603 Views
- 2 Solutions
drive'n and i thought i ran out of gas /try to...

when low on gas the impuritys in the tank can clog the fuel filter, so if the fuel pump has air in it , it might not be able to overcome the...
- anyglassunee
- Jan 23, 2010
- 103 Views
- 1 Solution
Is there an ODB Port on a 1990 Ford Econoline van

yes there is a odb port it under the hood on top of the wheel well on the right side....
- cgeetch
- Nov 20, 2009
- 210 Views
- 2 Solutions