http://www.fixya.com/cars/p696570-ford_1993_probeSolved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comTue, 15 Dec 2009 06:37:13 GMT80http://www.fixya.com/support/t3468501-alternator_water_pump_belt_keepWhy does the alternator/ water pump belt keep breaking? I get a squeal then it shreds.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3419991-causes_93_ford_probe_idle_betweenwhat causes a 93 ford probe to idle between 250-500 RPMs?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3341469-dnt_spartplugs_powerdnt have spartplugs powerTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3333568-head_lamps_light_up_but_will_not_movehead lamps light up but will not move down and hide when turned off.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3323328-1993_ford_probe_gt_idles_fine_but_cuts1993 ford probe gt idles fine,but cuts off as soon as you touch the gas pedal. have already replaced plugs and wires.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3272692-need_vacuum_fuel_system_diagramneed a vacuum and fuel system diagramTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3166709-engine_interferingis the engine interferingTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3262438-93_ford_probe_4_cylinder_wantI have a '93 Ford Probe (4 cylinder) and want to remove the power steering pump. Where can I find diagrams on removal of the pump?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3272629-engine_dies_after_2_minutes_willengine dies after 2 minutes, and will restart if i pull the throttle manually acts like its not getting fuel. ik thinking fuel filter, pump, or vaccuumTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3217317-dont_know_much_oil_need_oil_changei don't know how much oil i need for an oil changeTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3207445-icm_inside_distributor_needif my icm is inside my distributor do i need to replace the whole distributor or can i replace just the icm 1993 v 6Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3197941-working_93_probe_gt_when_turnI'm working on a 93 probe gt when I turn the ignition I get all the lights, fuel pump, bells but no cranking. Pulled the starter it's good. I can get it to run if I hot wire it from the solenoid to the battery. I have voltage on the ignition wire to...Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3131857-car_stalls_out_when_let_off_gas_pushcar stalls out when I let off the gas a push the brake. Sometimes when I just let off the gas and let it slow down itself the check engine light comes on. But when it stalls out the check engine light and the fuel cutout light comes on.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t3093631-headlights_1993_probe_dont_go_downwhat can I do?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2903688-c_low_pressure_port_2003_gmcwhere is the a/c low pressure port on 2003 GMC EnvoyTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2899382-car_wont_start_lights_in_dash_but_nomy car wont start it has lights in the dash but no power whats so ever its not the battry because i tried a brand new 1 that i hadTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2855041-c_deosnt_blow_cold_hot_days_fre_iona/c deosnt blow cold on hot days,fre-ion level is good ,and condenser is coldTue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2807233-1989_4_cyl_will_run_until_hot_stallsMy 1989 Ford Probe 4cyl 2.2L will run just fine until the engine warms up, then it stops. I can rev the engine up and it will keep running until I put it in gear then it stalls. Please help.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2311693-dies_after_starting1993 ford probe gt, starts then dies in less than a minute. Then won't start for a while....Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2736307-blown_pistonblown piston on 1993 ford probe mechanic says I need a new motor re built 1100.00 - 90 day guarante Jasper motors. 900 labor do you think this is about accurate.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2119870-overheating_missingplug,wires,cap,rotor button,thermostat,and fuel filter is all new but my car is still overheating and missing but only when is is in gear, is fine in the morning and during idle, any suggestions?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2673461-replacing_power_steering_pumpreplacing the power steering pump on a 1993 Ford Probe?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2586992-93_ford_probe_starter_ground_wire93 ford probe with the 2.0L starter ground wire gets hot when key is in the ignition or cranking possition. just did a motor swap because the old one ran out of oil. any ideas on y the starter ground is getting so hot or maybe a full engine wiring...Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2617261-93_v6_probe_gt_will_not_startcar used to start  and run fine then it  started just dying sum-times  so i would restart it and it would run fine for awhile then it started dying more often and sum-times it wouldn't restart  until...Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2550307-thermostat_ford_probe_lxWhere is the thermostat on a Ford Probe Lx and how do I change it? What direction does the thermostat point when installed?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2535680-93_ford_probeoil pressure gauge shows low,but the dip stick shows its full,i put like five quart in it,the engine makes a tap,i was thiking it was the oil pump bad,but i drove it a few blocks and it stops.Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2519728-1995_probe_gt_as_right_now_notI have a 1995 probe gt and as of right now can not seem to change votlage on tps to get it at 5.0 votlage with harrness disconted and key on(engine not running).I had gain on tps befor egr code came up.This seem's to be the answear to votlage cut out...Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2523189-starter_located_ford_probewhere is the starter located on a ford probe?Tue, 15 Dec 2009 06:37:14 GMThttp://www.fixya.com/support/t2514517-93_ford_probe_kills_when_let_off_gas93 ford probe kills when i let off the gas, is starts up fine ,after it warm up it killsTue, 15 Dec 2009 06:37:14 GMT