http://www.fixya.com/cars/p695774-chevrolet_1986_k1500Solved technical support problems provided by FixYa users.en-usCopyright (c) 2007 FixYa, LTD. All rights reserved.info@fixya.comWed, 09 Dec 2009 01:41:43 GMT80http://www.fixya.com/support/t3595953-truck_350_4_barrel_just_wont_startmy truck has a 350 4 barrel and it just wont start it almost wants to but it wont is it the carbWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3564307-when_ply_brakes_slow_down_just_beforewhen i ply brakes to slow down just before i stop the rears lock up ,or if i stand on brakes fast rears lock up????????????Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3477663-truck_not_move_in_2wd_but_will_in_4wdtruck does not move in 2wd but will in 4wd. is my trans case or tranny shot??Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3427646-86_chevy_k10_e_brake_pedal_stuck'86 chevy k10; the emergency brake pedal is stuck down, how do I fix that to make sure it is releasing the e. brake?Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3298979-im_installing_new_flex_plate_new_chevIM INSTALLING A NEW FLEX PLATE ON A NEW CHEV 350 GOODWRENCH MOTOR. IM USING ARP BOLTS. ARP INSTRUCTIONS SAY, TORGUE TO 75LB WITH MOLY GREASE OR 115LB USING 30 WT OIL. OTHER SPEC CHARTS SAY 60LB WITH THREAD LOCK. I WENT WITH 30 WT AT 115LBS. IS THAT...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3256378-ase_test_questions_answersASE test questions, Help with passing the ASE A-5 brakes testWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3205248-just_brake_pads_replaced_1986_chevyJust had brake pads replaced on my 1986 Chevy pickup 1/2 ton and now the driver side brake wont release it sticks. Is the brake lines bad or what? ThanksWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3128437-blower_moter_heater_not_workblower moter on heater does not workWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t3086735-87_chev_1500_silverado_dual_fual_tankson 87 chev 1500 silverado with dual fual tanks the fuel pumps won't work ,pumps have been tested already out side the system,we are thinking the tank switch over isn't working.Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2983398-remove_spindle_86_chevy_4x4I cannot seperate the spindle...trying to replace the ball joints both upper and lower). I have hammered and hammered to break it loose.Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2864356-86_silverado_needs_power_wireI have a 86 silverado that needs the power wire ran from the tank to ?? I dont know where this goes. Someone has removed all the wiring leading back to the tank. If anyone can help I would appriciate it.Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2706873-just_bought_77_chevy_motorhome_454_ini just bought a 77 chevy motorhome with a 454 in it. it idled great, drove great at first, even when hot. took it out and opened it up, and then died. now it wont idle. timing?Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2540010-headlights_wont_workmy dash lights will always stay on. i try to turn them off with the headlight switch and it pops the fuse. my brake lights and blinkers still work properly. i put a brand new headlight switch in and it still does the same thing. and my headlights and...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2807653-4_wheel_service_lightI have a 2001 Chevy 4X4 Z71 package. The check 4 wheel drive light comes on some times. it seems to come on more often when the weather is warmer. Most of the time the 4 wheel still works but sometimes it does not. A few times the 2 wheel or 4 wheel...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2732661-need_sensor_diagram_locate_check_sensorsneed sensor diagram to locate and check sensorsWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2694869-need_wireing_diagram_window_switchesneed the wireing diagram for the window switches in a 1986 chevrolet pickupWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2574535-hood_latch_1986_chevy_pickup_brokemy hood latch on 1986 chevy pickup broke at the latch and I cannot get hood open, even took grill off trying to get to latch. What can I do?Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2406814-1986_checy_4x4_plugs_replaced_fuelI have a 1986 checy 4x4 , plugs replaced, fuel filter air filter...Idle is really high and now after i let off the gas pedal is still goes around 80 km's, and will not slow???Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1961146-1990_chevy_truck_454_v8_idles_highI have a 90 454SS chevy truck. The truck idles about 750-850 rpm`s in drive. I changed the Idle Air Control and it didn`t seem to help. When you crank it after it is good and warm, it starts idling about 400 rpm`s but after about 45 sec. it goes back...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1867025-454_chevy_idleWe have a 1990 chevy 454, that the fuel filer stopped up, we put a new one one, then the truck would not idle, so we replaced all the plugs and wires, and it still won't idle really need helpWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2263864-brake_caliperi have a 1986 chevy truck with a caliper that sticks so i put a new one and it does the same thing on driver sideWed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2261647-brake_problem_chev_k_1500_4x4_absHi, the brake oil in the font part of the reservoir goes down but I can`t find a leak anywhere. When I push on the brake pedal the brake oil in the back part of the reservoir does like a water fountain but does not over flow.I know that the calipers...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2209703-95_chevy_k1500_stuck_in_4x4_lowthe manual selector moves fine and you can hear it clicking in the front driveshaft when it moves to 4LO or 4HI position. I know the front axle lights on the drive selector used to work and now they don't light up any more. Am I looking at an...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t2181215-more_one_size_drive_shaft_truck_oneI have a a1998 chevy pickup 4x4 1-2 ton I need a drive shaft. the one I took out is steel and the one the salvage yard game me is alumium. I seems to big. Is there differt sizes for that year truck??Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1516570-chevy_1993_half_ton_4_wheel_driveno four wheel drive for a 1993 chevy half ton 1500 series four wheel drive already changed the actulator and tranfer case switch.Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1812817-1989_k_1500_brake_problemsI have new front calipers and new rear wheel cylinders. A new proportioning valve and a new master cylinder.When I bleed the brakes I get good fluid out of the back two and the right front. The left front just trickles out. also when I'm driving and...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1615846-1993_chevy_silverado_new_motor_headersI switched from fuel inj, to carb... got a new motor all together, vortec 355 My Old Manafolds wouldnt boltup to my new motor, my old motor was 350, i had to have a oil filter adapter just to keep it from hitting my Front driveshaft 4x4, same thing...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t1571774-1994_chevy_1500_4x4_will_not_drive_inHey, appreciate if somone could give some insight into this situation. My truck (above) has all other forward gears, even 4wd - but will not drive in reverse - either in 4wd or 2wd. Well, it drives a little in reverse when it wants to, but almost...Wed, 09 Dec 2009 01:41:44 GMThttp://www.fixya.com/support/t893112-engine_stallingengine stallingWed, 09 Dec 2009 01:41:44 GMT