20 Most Recent
1988 Chevrolet C/K 3500 Questions & Answers
Installing drive belt
If it is a serpentine belt, there is a sticker on the radiator bracket that shows the configuration. You move the belt tensioner pulley to release the tension on the belt, replace the belt, and move the tensioner back into place.
No headlights, tail lights, running lights, turn
Hi LuisSome Chevrolets have two fuse panels. One under the engine hood,and another in the side of the dash or under back seat...check this,and if so,recheck those fuses acording to the diagram on the lid. 2nd....check for short to fuse panels...good luck
Power to red wire on coil no power to distributor wires
Yes the crank sensor could keep the coil from firing, but your truck does not use a crank sensor assuming its a V8.The coil gets power from the key switch, and the ignition module inside the distributor grounds the coil to fire it.So the problem could be the coil, or the module or pickup in the distributor. The pickup coil in the bottom of the distributor acts as a cam and crank sensor.You may need a repair book or shop manual to get the test procedures.
1998 chevy 3500 brake lights stay on
I'm going to comment on this but don't quote me.There is a tab or pin in the side of the switch that has to be moved to allow the switch to self-adjust. There should have been instructions in the box. You have to push the tab in or hold it to move the switch then release it. I don't think the switch should move with the pedal.You can check with the parts store about the instruction sheet.Or the GM dealer.
Not finding what you are looking for?