I have a 1994 chevy s-10 blazer, Have no reverse and won't shift out of first. there was no noise,...
(More)
I have a 1994 chevy s-10 blazer, Have no reverse and won't shift out of first. there was no noise, no clanking nothing. just put it in reverse; and then nothing. Put it in drive and it went real slow and would not shift out of 1st. does this sound like the whole trans went out, fixable or needs another one.
94 Chevy blazer 4x4 Hi and Low only work if i have the ignition in accessory position, if i turn the...
(More)
94 Chevy blazer 4x4 Hi and Low only work if i have the ignition in accessory position, if i turn the key to start the engine it doesn't do anything, possible fix?
my wire coming out of the fuse panel on number 4 fuse is burnt can u tell me where those wires go to...
(More)
my wire coming out of the fuse panel on number 4 fuse is burnt can u tell me where those wires go to the wire comes out of the fuse panel an then is spliced together an 2 go under the hood an the other goes through the dash the wires are pink an black
1994 S10 Chevy Blazer 4x4 w/4.3 Vortec engine stops after 6 minutes. Car runs 6 minutes then stops....
(More)
1994 S10 Chevy Blazer 4x4 w/4.3 Vortec engine stops after 6 minutes. Car runs 6 minutes then stops. Fuel pressure, oil pressure, temperature and spark ignition all good. Fuel injectors not energized. Exhaust coming out of exhaust pipe when running. Service engine soon light doesn't come on. Wait half hour, car will restart for 6 minutes, then stop again. Changed ECM and still has same problem. Do you think ECM, PROM or sensor problem?
2003 chevy S10 third door latch is jammed with the door closed. panels is off and handle (broken)....
(More)
2003 chevy S10 third door latch is jammed with the door closed. panels is off and handle (broken). How do I get it open to remove the latch
the poppets wont shot gas in to the cylinder,replaced and checked intake fuel unit,relay works,going...
(More)
the poppets wont shot gas in to the cylinder,replaced and checked intake fuel unit,relay works,going to check fuel pressure today,does fp have to be above 47psi to make system actuate and disperse fuel,and the comp is supposed to ground unit,there is .523 ohms of resistance at the comp,is this affecting the unit as well or is a certain amount of resistance "normal"?,at the comp or should i suspect the comp?
2005 audi a6 2.7 diesel . esp light comes on after 5 mins. fault code stored in engine ecu is u1007...
(More)
2005 audi a6 2.7 diesel . esp light comes on after 5 mins. fault code stored in engine ecu is u1007 asking me to check the battery monitoring system . the battery voltage does not drop below 14 volts . hope you can help