20 Most Recent 1996 Mazda Pickup Questions & Answers

perhaps the code has cleared? Try unplugging O2 sensor and starting / removing 1 plug wire etc. to induce code to verify light?

1996 Mazda B2300 Pickup Truck Service Repair

You say that but something is wrong!! If the engine is catching then the fault may not be major. I am assuming the vehicle is gas rather than diesel... Check the sparl plugs are clean and undamaged and correctly adjusted. Check they all give a good spark. Uou say that fuel is present, it has to coincide with the introduction of the spark in the combustion chamber...if it does not the vehicle will not work. If all plugs give a very good spark check the fuel supply is adequate and then the timing. If the plugs give a weak spark at the electrode replace the wires also check that the distributor cap is in god condition. A weak spark might also be associated with a failing coil/coils Ensure your battery is full of electrolyte and is fully charged GOOD LUCK

Lean bank 1. Possible vacuum leak, low fuel/restricted pressure or stuck o2 sensor.

drain ? what is the meaning pull?drn oil to remove the drain plug & change oil filter as well,fiil oil & check oil level by dip stick

If the check engine light is on, have you checked the engine computer for trouble codes ?

Possible for a speed sensor failing. Not sure on those trucks.

Low oil pressure is caused by bad bearings, low oil level. faulty oil filter, pump pressure regulator faulty and wrong grade of oil .AS to the other run the fault codes to check for faulty sensors.( probably MAF sensor )

could just be a bulb would check that first if thats the only thing not working on your dash but that like does not usually go out so i would also get the codes ran

Yes it is.

I see no question here??

yes as far as i can remember it is

Does your owners manual tell you what circuit fuse number 24 protects ?

I would get 2 the same keyed alike from a salvage yardFrom there a lock smith maybe able to reprogram if nec

Must be put on alighnment machine. Take to shop.

What you have coils or distributor cap,this causing problem,this have to be replace,