HI, I have a 1991 2500 4X4 with a no start condition. The vehicle has ignition spark to the dist and...
(More)
HI, I have a 1991 2500 4X4 with a no start condition. The vehicle has ignition spark to the dist and plugs. However no injector pulse on the ground side of the circuit from the ecm. The voltage to the injectors are present. Any ideas?
I have a 1991 GMC surburban,it wont start, too much fuel (floods). changed the coolant temp sensor,...
(More)
I have a 1991 GMC surburban,it wont start, too much fuel (floods). changed the coolant temp sensor, put on a different throttle body(with different sensors), and also changed to a different ECM, still way too much fuel..What should I do next
Hello,i am trying to figure out why the front axles or differential makes a loud clunk every 1/2...
(More)
Hello,i am trying to figure out why the front axles or differential makes a loud clunk every 1/2 mile or so.The 4x4 did not get used for along time,i replaced the 4x4 acuator that engages the axles and since then it has been making the loud clunk.I have made sure it is in 2 high,i have tryed reversing several yards.I have removed the acuator temporarily to see if that helped but nothing changes,this is a loud clunk like it is trying to engage.Any help would be great.Thank you!
I am looking for a diagram to the fuse box for a gmc 1995 suburban my headlights are not working and...
(More)
I am looking for a diagram to the fuse box for a gmc 1995 suburban my headlights are not working and I belive it is a fuse that blew out
1999 Surburban - 1. motor will not rev over 1,000 2. motor skips----only after running for a...
(More)
1999 Surburban - 1. motor will not rev over 1,000 2. motor skips----only after running for a while....runs smooth upon startup 3. will not go over 20mph Have replaced o2 sensor stage one, cap, rotor, plugs and wires. Using mid grade gas. What could be wrong? LG
i have a 1999 gmc surbrban, same problem as lefty64 i work the override button and still no lights....
(More)
I HAVE A 1999 gmc SURBRBAN, SAME PROBLEM AS LEFTY64 i WORK THE OVERRIDE BUTTON AND STILL NO LIGHTS. NONE OF THE DOOR SWITHES WILL TURN THE LIGHT ON. I CAN MANUALLY TURN THEM ON WITH THE WHEEL INTERIOR LIGHT SWITCH, ALL INTERIOR LIGHTS WORK FINE. HELP PLEASE..... PHIL
this is a tip for all those who are looking for free diagrams, free diagrams are very hard to get... allthough most of us have access to diagrams,...
written by jaysonemanme
This is the reset proceedure for a 2008 Highlander with a key-type ignition: Turn the key ON, do not start the engine. Look at the odometer, and...
written by Toyota Ed
There is a known issue with the 2005-2007 Corolla automatic transmission shift logic. The shift points may seem harsh, and the Check Engine light may...
written by Toyota Ed
There are two jam switches located on the latch assymbly. One on top and one at the bottom. They can become dirty and not function properly causing...
written by dlmcmasters
Believe it or not, it is normal for these engines to use about a quart every 2000 even when they are essentially new. Note that I said,...
written by chiquititas
I will explain this better! Turn off the radio and turn the key to the on position. Press and hold DISP knob, when info comes on window press the seek...
written by DAD5bbbbg
I just bought a 2008 jeep wrangler and my hood is lifting 2 to 3 inches off the frame when I'm driving on the highway in wind speeds over 15 to 20...
written by newmdog