Top 10 2001 Ford Crown Victoria Questions & Answers

The backseats of this vehicle do not fold down. They are placed on hooks and then they're bolted in on the bottom right and bottom left of the seat.

where is the fuel pump relay on a 2001 crown vic p71

well if you have checked the spark plugs and they look good then its probly the coil If the plugs have never been replaced i would start with a tune up and see if this fixes the problem. If not there is no good way for you to test it you would need a computer to hook up to the car

have fuel pump checked i have known a bad fuel pump shorting out causing pcm fuse to blow.

2000 Ford Crown Victoria Car Radio Stereo Wiring Diagram
Car Radio Battery Constant 12v+ Wire: Violet/Light Blue
Car Radio Accessory Switched 12v+ Wire: Yellow/Black
Car Radio Ground Wire: Black/Light Green
Car Radio Illumination Wire: Light Blue/Red
Car Stereo Antenna Trigger: Blue
Left Front Speaker Positive Wire (+): Orange/Light Green
Left Front Speaker Negative Wire (-): Light Blue/White
Right Front Speaker Positive Wire (+): White/Light Green
Right Front Speaker Negative Wire (-): Dark Green/Orange
Left Rear Speaker Positive Wire (+): Gray/Light Blue
Left Rear Speaker Negative Wire (-): Tan/Yellow
Right Rear Speaker Positive Wire (+): Orange/Red
Right Rear Speaker Negative Wire (-): Brown/Pink

Heres the belt diagram for your 2000 crown victoria, hope this helps you.

its on the fuse cover inner side or outerside

Hello abzalkhan193
Heres a few things to check that could cut power to the fuel pump. The fuel pump inertia shutoff sw
in the trunk on the left side, there is a reset button on the switch if you push the button down and
you hear/feel a click then the switch was tripped and you just reset it. The switch's job is to cut off
the fuel in case of an accident. Next, the fuel pump fuse located in the battery fuse block under the
hood on the right fender well, fuse #1 20amp fuse. Next, the fuel pump relay, the relay is located in
relay center on the left fender well. Hope this is helpful.

ned to remove the radio and look at the blend door actuator on top of the hvac box. the actuator goes bad and doesn't move the door from hot to cold. if you see the actuator moving but still no cold air then the blend door could be broken.

You can't by-pass this system. Try locking/unlocking the doors with the key fob. If that doesn't work, try locking/unlocking the drivers door with the key. If still no luck, try disconnecting the battery for a minute or so. Do you have another key you can try?