20 Most Recent 2004 Mitsubishi Outlander Questions & Answers


The immobiliser works with a chip in the fob. This is a signalling device which, via a pick-up situated around the ignition lock, sends the signal to the engine computor which the allows the engine to be started.

2004 Mitsubishi... | Answered on Mar 22, 2019


check the fuse for the dash lights

2004 Mitsubishi... | Answered on Mar 15, 2019


I got this free Pdf manual from reliable-store for free and I don't think Ive visited a mechanic or fixya for help for more than 3-4 times out of the 20 times I fixed the chipper in these 4 years

2004 Mitsubishi... | Answered on Feb 11, 2019


Looking at wiring diagrams for the electrical circuits of the affected system's ,getting out a DVOM - digital volt ohm meter an then testing the affected systems electrical circuit's is how to diagnose these type problem's . Looking at wiring diagrams to see what all is involved in all these circuit's too . Having the vehicle checked for DTC'S - diagnostic trouble code's would be a very good idea , looking at wiring diagram's i see all the thing's your having problems with are control by ETACS - ECU control module . Suggest you take your vehicle to a qualified repair shop . You probably fried the computer . An new computers need to be programmed , that means dealer in most case's .
Free wiring diagrams here http://www.bbbind.com/free_tsb.html
Enter vehicle info. year , make , model an engine size . Under system click on body & accessories ,then under subsystem click on power lock's , power window's etc.... look at them .

Electric Testing Techniques You Need to Know

Testing an not guessing is how to fix electrical problem's .

ECM Inputs and Outputs Diagnosis

2004 Mitsubishi... | Answered on Dec 21, 2017


If you fitted a new battery which drained overnight, that points towards a discharge somewhere in the electrical system. The battery charge is finding its way to earth somewhere.

One of the usual causes of battery discharge is a faulty alternator - the diodes in the rectifier pack (usually attached on the end of the alternator) burn out, allowing the current to run to earth.

Disconnect the wiring from the rear of the alternator and charge your battery and let it stand overnight, with the alternator wires disconnected.

If it starts ok in the morning, that's pointing towards a burnt out rectifier pack.

Other causes of battery drain - well - they can be caused by anything in the electrical system including the instrument cluster.

There will be sensors on the throttle body. Check the wiring on the sensors. If you're getting an error code that's suggesting you have a sensor problem.

If the engine cranks but doesn't fire - it's a sensor at fault, usually. Though it could also be due to a broken or corroded wire to one of the sensors/ECU.

If the engine doesn't crank that points towards an earthing problem. Check the battery cables for security and corrosion - particularly check the black earth cable where it attaches to the engine block.

2004 Mitsubishi... | Answered on Sep 27, 2017


Change your blower motor resistor,it's located next to the blower motor.

2004 Mitsubishi... | Answered on Aug 03, 2017


There is an electrical short in the system. Have it checked by a professional.

2004 Mitsubishi... | Answered on Aug 03, 2017


If you know about timing belt driven water pumps.. you know that you have to reset your timing on the engine. If you think you can. Tear it down.. replace the pump. And go onto the internet and find that engine and ask for timing marks.. reset them.. and all will be fine.. hope this helps.

2004 Mitsubishi... | Answered on Apr 22, 2017


Check the connecter of you battery. There's a good chance your battery connecters are loose, or another problem with your battery connecters.

2004 Mitsubishi... | Answered on Apr 09, 2017


There are two fuel pump relays located in the junction block.

2004 Mitsubishi... | Answered on Mar 06, 2017


check your lighter fuse if its blown that's it.
phone charger outlet not working ?

2004 Mitsubishi... | Answered on May 01, 2016


You have to access the lens from under the hood. There will be adjustment screws that also hold the lens in place. Remove those and it snaps out. They are in there firm so be ready for a little fight.

2004 Mitsubishi... | Answered on Apr 27, 2016


could just be air trapped in factery thermostats have air hole after markets do not.so first let it coll down.then fill at radiator cap start up make sure fluid is moving probly alt of air intall cap park car on hill driver side up let run untill hot and repeat should get all the air out

2004 Mitsubishi... | Answered on Dec 01, 2015


sounds like rear diff mount when tranny shifts and its worn it will thud pretty bad

2004 Mitsubishi... | Answered on Dec 01, 2015


I provided this info to you in a previous post.

2004 Mitsubishi... | Answered on Oct 03, 2015

Not finding what you are looking for?
2004 Mitsubishi Outlander Logo

330 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Outlander Mitsubishi

  • Outlander Mitsubishi

Most Popular Question

mitsubishi outlander 2004 tendency

  • Cars & Trucks
Loading...