2007 Chevrolet Malibu SS Sedan New Cars - Answered Questions & Fixed issues
Keyless entry
There are no wires you can touch to program key fob's , Dealer only ! Need a factory scan tool !
This procedure will erase all keyless entry transmitters from memory.
Install a scan tool.
Turn ON the ignition with the engine OFF.
With the scan tool, select Body.
Select Remote Control Door Lock Receiver (RCDLR).
Select Module Setup.
Select Program Key Fobs.
Select Invalidate All.
Follow the scan tool on screen instructions.
Equinox computer error codes
Just trying to logically get through this...
Stabilitrak is the electronic stability control system, which is the evolution of ABS. So, an ABS failure would also mean that stabilitrak wouldn't work.
Could there be an electrical problem, like two wires shorted on each other? It's like one wire overheated and burned through, then burned through an adjacent wire a couple of minutes later...
for more software help visit
https://cbrtechsolutions.net
Chevy malibu
There are several things in the transmission that could cause this. Bad converter, bad pump, bad seals. Just to name a few. If you have the CVT transmission, then there are other problems that could exist.
Keeps popping the fues
Ya ,if you keep installing a new oneOnce a fuse blows, you don't replace itYou look at wiring diagrams to see whatthe most likely cause would be, to blow a fuse,then start your testing.How exactly would one guess from here
2007 Chevy Malibu where is fuel relay(s) and how can I test it?
We are not going to tell a professional how to do their jobIf the mechanic is describing voltage drops, then he haswiring diagrams & knows what he is doingCodes have nothing to do with where he is at nowHe is component testing to get the fuel pump circuit up
2007 chevy malibu wont start
I hate to say this but the bearings may have seazed and frozen up on their jurnals due to the lack of oil. the engines only holds five quarts to start with,so it could not have been getting any oil if it was three quarrts low. Sorry. Engine likely no longer usuable w/o changing the bearings and crank.
Programming a micro chip key for a 2007 malibu
Key FOB programming is definately not a dealer only job, as much as they'd like
you to think it is!:disappoin Try this procedure. It's a pretty standard
procedure across the GM line: (write-up compliments of nat3ten from trailblazer
forum)"1 SIT IN VEHICLE AND CLOSE DOOR2 HOLD FINGER DOWN ON
UNLOCK POWER
DOOR LOCK SWITCH ON DRIVERS DOOR.3 put key in
ignition, TURN IGNITION ON / OFF , ON / OFF.LEAVE KEY IN IGNITION.(DO NOT START
VEHICLE, ON POSITION IS THE POSITION BEFORE START)4 RELEASE FINGER FROM
POWER DOOR LOCK.POWER
DOOR LOCKS WILL CYCLE.(JUMP UP AND DOWN)5 PRESS
AND HOLD BOTH THE LOCK AND UNLOCK BUTTONS ON NEW REMOTE UNTILL YOU HEAR POWER
DOOR LOCKS CYCLE.(JUMP UP AND DOWN) YOU MAY HAVE TO HOLD BOTH BUTTONS DOWN FOR
5- 20 SECONDS.6 TAKE 2ND NEW , OR OLD REMOTE AND HOLD BOTH UNLOCK AND
LOCK BUTTONS DOWN UNTILL LOCKS CYCLE.(MAY TAKE 5- 20 SECONDS)7 TURN
KEY ON, THEN OFF.YOU ARE DONE, EXIT VEHICLE AND TRY YOUR REMOTE."
Not finding what you are looking for?