20 Most Recent
2007 Mercedes-Benz CLK-Class Questions & Answers
Rust on brake rotors
sandblast the and machine the rotors were the pads apply pressure to stop
1/31/2010 3:14:30 PM •
2007...
•
Answered
on Jan 31, 2010
''B'' Camshaft Position - Timing Over-Retarded Bank 1
When dealing with the camshaft positioning sensor, this should be done by a certified mechanic.You can purchase a Chilton's repair manual for this auto, but I don't believe it will be of much help. I had the same problem on a newer ford, and wasn't equipped to do this job.Try giving the Mercedes dealer a call, and talk to one of there mechanics. I hope I have been some help to you.
Sincerely, shastalaker7
10/30/2009 2:28:58 PM •
2007...
•
Answered
on Oct 30, 2009
Hi i have toyota lexus
There is no such model as a Toyota Lexus . Please clarify model letter code and number ie I drive a LEXUS RX300
9/11/2009 12:42:34 PM •
2007...
•
Answered
on Sep 11, 2009
How dependable is the Mercedes 722.6 transmission?
most Mercedes cars mechanics are pretty bullet proof but as in all cars you do get bad ones no car is totally reliable the only problem Mercedes had was the rust problem which they have now solved but now as all cars they have filled them up with electronic gismos so there is something else to go wrong
Why won't my 2002 Clk 430 crank and shift into drive? It was in a minor accident.
depending on the amount/location of damage to the vehicle you could have damaged the wiring harness leading to blown fuses, or damaged important sensors/relays that, if damaged, wont allow the vehicle to start. or you could have tripped the rollover switch which cuts the power to the engine in the event of a rollover to help prevent fires. but can be set off if damaged or hit hard enough. Start checking fuses and wiring on the damaged part of the vehicle. I hope this info helps.
I left top half way
first try with disconnect battery ground cable, disconnect cable an leave 2 minute then fix it back and have a look, if not work now it's position uneven, you must close the roof slowly by hand up to locking position after that first operate the switch for closing and let it lock properly then till lock the boot lid to the right position with two flaps then switch off ignition let it stay 5 minute without doing any thing and, after that open the roof, if not work in this way you must fix Mercedes diagnose tool in to the car for manual activation through diagnose tool, and also would like to ask you to check the boot separation flap again is it in the right position if it not close properly it won't work,
Not finding what you are looking for?