20 Most Recent 1975 Volkswagen Beetle Questions & Answers

Drivers side floor look up under there fir a silver round looking small can that is the relay it is under the drivers side dash.

Timing is off or bad plugs points or wires start with a tuneup if you already did that then check the plug wires you may have one crossed.

Hi. What rear axel type do you have? Is it a 1975 beetle hub?

Question edited for clarity. Question moved from Motorcycles. If it didn't backfire before the rebuild, then it wouldn't be the carburetor jets. Check the ignition timing and for inlet manifold leaks, and exhaust leaks. https://www.google.com/search?q=VW+1641+backfires ,,

Got it!!! The doors may be locked but the car doesn't think so! The culprit... the gas door lock is sticking!! WD-40 the lock on the gas door and problem solved. Also got a new battery so it could be a voltage surge from a battery going bad.

so all std brakes are good? pads, rotors and calipers? if not and are bad ABS goes mad, ABS is last to fix, not first OK> abs can not hid for example, a brake caliper piston rusted to ***** after 19 years..old.(and will be that old I say how can it no be so?>) all that and not one DTC posted (ALL) HERE ? amazing this... and when you replace any part here, reset the all DTC now with the scan tool, buy one, you can not fix (diy) modern cars with no tool. or rotor guide pins seized, fix the mechanical brakes first.!!! they all must be good, end to end ,sure a weak pad (a tad) the ABS can hide it. well kinda. (normal wear yes, ugly no) or take the car to a real brake shop and watch them and learn the craft and skills. or take An ASE brake course. nobody here can guess what is wrong or done wrong, that be impossible other than a simple pep talk,.

The compressor clutch uses a lot of current and would be controlled by a relay. Also there is probably a low refrigerant switch in the system that wont allow the compressor to come on if the pressure is too low.

Volkswagen Jetta 2003, error codes KWP2000 and ISO9141 ...

https://www.autocodes.com > volkswagen-jetta-error-co... Feb 20, 2017 · 1 answer These are communication protocol they are not codes a code reader displays as "P" depending on the scan tool that you have once you connect ...

The batteries are flat. They are inside the tire. Garages usually just replace with a new set of monitors complete.

Question translated into English. Question moved from Televisions to Volkswagen Beetle. VW don't supply free manuals! $9.00 here https://dubmanuals.com/downloads/2000-volkswagen-beetle-owners-manual-pdf/ One section of the manual posted here https://www.volkswagenownersclub.com/threads/2000-new-beetle-owners-manual-section-3-2.20495/ https://www.google.com/search?q=2000+volkswagen+beetle+manual ..

I know this is going to sound crazy but some VW have a censor in the drivers door so when you open it the fuel pump automatically primes the engine .. Check that . Chuck

Don't do parts on here . VW Stockest is you best bet

No it is not adjustable

If you are trying to squirt water from the wiper jets and nothing happens, you need to replace the fuse. The fuse is located within the fuse box in the engine bay, open the lid and see which one needs to be replaces using the provided map on the cover. If there is no map, follow this link for a copy: https://www.autogenius.info/volkswagen-new-beetle-fuse-box-diagram/

what model ?? normally its 1342 ,but if its the flat four old type engine then its 1234

epc is short for electronic pedal control, the throttle is controlled by an electric motor and has two angle sensors in the throttle body. the pedal it self has two sensors as well, sometimes after a battery replacement or replacement of certain parts (ecm throttle body pedal controls) the control modules need to be reset or "relearned" to one another. the dealer or independent shop with correct softwear can do this, if problem persists possible bad throttle body pedal sensors or ecm (engine control module)

you mine is not working?