20 Most Recent 2008 Opel Corsa 1.4 Questions & Answers


The reason they work with the engine OFF is that they are not spinning so there is nothing stopping them moving in and out of position.
Ill need a bit more information to give you more help.
Is this a manual or an automatic vehicle? Does it do anything else when the engine is running? Does it make noises like grinding or crunching? Does it jump roughly as it goes into gear or slip into gear? Please comment below and I'll try to help you more.

2008 Opel Corsa... | Answered on Jul 12, 2019


idle control valve may be blocked. sits on the back of the intake carb. also lose intake top can give erratic ideling

2008 Opel Corsa... | Answered on Jul 11, 2018


Try any auto parts store . they will know the price also .

2008 Opel Corsa... | Answered on Aug 10, 2016


This car has a CAN-bus electronic system. Suggest you invest in a cheap OBD fault code reader from Amazon or eBay. This will help you pinpoint the problem.

2008 Opel Corsa... | Answered on Aug 02, 2016


Check battery ground cable where it attaches to the car engine block or body. Make sure it is clean and tight.

2008 Opel Corsa... | Answered on Nov 15, 2015


it is good mechanical practice to replace all bolts that are operating under tension. That includes con rod bolts , big end bolts fly wheel bolts , head studs and crank shaft bolt. Some manuals recommend the replacement of cam shaft sprocket bolts as well. This practice is recommended where the engine is driven at high rpms. It is recommended practice because the tension effect actually twists the bolt and this combined with the tensional stress makes the bolts prone to failure. As it adds considerably to the cost many mechanics do not follow the practice but will charge for the new bolts as well.

2008 Opel Corsa... | Answered on Dec 01, 2014


there will be no movement in the mounts unless the suspension rubber/ bushes are worn out . There will be no figures as it amounts to the fact that if you can move them then they will need replacing. take it to an accredited suspension shop and have a safety check done and have them show you what is worn and needs replacement and calculate how much you will save by doing it yourself against what they will charge for a good -safe-guaranteed job.

2008 Opel Corsa... | Answered on Jun 04, 2014


ABS I'd first have it checked I'd say it's a faulty ABS sensor hope this helps but please have it seen to for your safty

2008 Opel Corsa... | Answered on May 30, 2014


This is caused by the display unit slowly failing and it is a common problem on Opel & Vauxhall cars. The internal circuit board is fed by a flat ribbon cable with many tiny connections. Heat, vibration and age will often cause one or two of these connections to fail, which results in dead pixels on your screen. The best solution is to buy a new display unit, although if you research using Google you may find somebody who offers a repair service.

2008 Opel Corsa... | Answered on May 26, 2014


What spark plug wire? A 2008 Corsa has a sealed coil pack connected to all four plugs and bolted to the cylinder head

2008 Opel Corsa... | Answered on May 26, 2014


Suggest you get a cheap OBD2 code reader from eBay, plug it into your car's diagnostic socket and read the fault codes displayed. Then google for what the codes mean.

2008 Opel Corsa... | Answered on May 26, 2014


That sounds like the fuse

2008 Opel Corsa... | Answered on May 17, 2014

Not finding what you are looking for?
2008 Opel Corsa 1.4 Logo

39 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Opel Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Brad Brown

Level 3 Expert

18067 Answers

george parkes

Level 3 Expert

980 Answers

Are you an Opel Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Corsa Opel

  • Corsa Opel

Most Popular Question

need opel corsa lite 1 4 petrol pump get

  • Cars & Trucks
Loading...