20 Most Recent
2006 Nissan Murano S Questions & Answers
Tengo el codigo P0456 y
Tengo un honda civic 2013 empieza a salir primero la luz del tampon de la gasolina luego la del check le cambie el vapor ganister purg,EGR valve solenois y el tapon de la gasolina pero no es el original fue remplazo y me da el codigo P0456 de una peque?a fuga..Que podria ser?
My nissan murano 2008 station wagon still locked after engine is off
all that is DIY programmable, per your users guide(in glove box)
and if battery main went dead it sure can forget all that.!
and goes to factory default settings . ( by design)
car starts and runs ok
key fob batteries all new. and fresh.?
I have all that in our cars turned off, I like being in control.
auto locks and unlocks are programmable in my key fob chapter of my users guide, like most cars are. (or configurable)
no told at all what else works great , like driving and head lamps etc.
cars have like 50 fuse and 50 feature now, do some work?
What's the torque for all four caliper mounting bolts behind dust plate and axle/wheel bearing/CV nut?
Assuming your Nissan is a 2016 or newer, the four mount bolts are 65ft/lbs, (88Nm).
For the 'CV' nut do you mean the large nut on the end of the drive shaft? That nut is tightened to 135ft/lbs, (182Nm).
This is a very tight setting so you will probably need to 'wedge' the brake disc to stop it turning as you tighten it. Try fitting two wheel studs next to each other and fully tighten them. Get a helper to hold a pry bar between the studs as you tighten the nut.
2007 Nissan Murano, cranks but wont turn over can't figure it out
If the engine sounds as if it wants to start, it is possible that you just have too much gas in the manifolds or in the cylinders. Try the following: Turn on the ignition but do not start. Hold down the gas pedal for a minute or two. Then start the car without releasing the pedal. I know some will say this method will not work with "drive by wire" systems such as MO's but I think it will.
More than likely though, the problem could be the anti theft system interfering, or locking down the ignition. Close all doors and then using your key (not the fob) lock and unlock the doors several times and then try.
I HAVE A LOUD NOISE COMING FROM MY NISSAN MURANO
Most likely "scalloped" tread on the tires causing noise but could be a wheel bearing or bearings.
Slide your hand on the tire tread,it should not have any high or low spots.
Also while driving if you can change the noise by moving the steering wheel a little to the left and right (changing the load on the bearings) then it would be wheel bearings.
I HAVE A 2010 NISSAN MURANO...I HAVE A LOUD NOISE
That most likely is a bad wheel bearing my friend. Jack each corner of the front and see if the wheel and tire will "shake" by trying to move the top of the tire in and out. On rear wheel drive vehicles, the rear axel will move in and out or op and down. If you spin the rear tire you may hear the grinding noise. Change that bearing where it moves or is noisy.
Not finding what you are looking for?