20 Most Recent 2006 Mazda 3 2.0 Questions & Answers

In the link https://www.google.com/search?q=diagram+for+cooling+system+2006+Mazda+3 ..

no not original transmisson not even on the vin plate only engines are recorded on registration papers .. vin plate decoded number will designate CVT , std automatic or manual gearbox mazda 3 BK series will have a designated gearbox fitted for the 2004 to 2008 models production run

Well, a battery with insufficient cold cranking amps or CCA will cause such a thing or similar things to take place. Also a malfunctioning ECM/PCM may cause such an issue as well.

Sounds like a bad wheel hub to me

Replace fuse 31 under the hood. It's going to be bend out of shape or burned out.

Here is your answerhttp://engine-codes.com/p0744.html

The 'freeze plug' is in the block, front and back, not the head.I is a disk if thin steel that is an interference fit and will knock out to be replaced without dismantling the engine. The correct name is Core Plug.

When you ran a test lead from the battery, did you run a separate ground wire to the bulb? If yes -- confirming no ground from the original lamp connection -- try inspecting the body ground closest to the lamp: Remove, clean w/ wire brush or steel wool (both the connector and the nut/bolt holding it to the body), then try again. If still no luck, check ALL the body grounds in the engine compartment. If there's still no ground, try using a "quick splice connector" to connect a grounded bypass cable to the original grounding cable, near the lamp. (These connectors can be tricky. Instructions say you don't need to strip the sheathing on the cables, but I usually cut the sheathing with a knife to make sure there's a good connection.)Regarding HID lamps: for running lights, do the main headlights come on w/ reduced power, or is there a separate lamp? If it's a main headlight, maybe there's an issue w/ a step-down transformer, or whatever system is used to dim the lamp.

Ask Mr Mazda what is wrong as it must be something to do with the Heat of the day or He did something so as he can make MORE money from you. Next time Rotate the tyres yourself as it will only take about half hour and cost nothing. You can than SHOUT yourself a few BEERS this the money you saved

Thats pointing towards the throttle body sensor.

Open the door from the outside and then take off the inner door panel to find the problem. It is usually the door handle that is broken.

Either a bad key or a bad sensor in the dash or where the key switch is that is not getting the signal from the key.

Bleed the clutch fluid to remove the air from the system. Make sure there is no play in the bushes of the gear linkages