? 4:00
www.youtube.com/watch?v=f8slwZ1hV0c
May 11, 2010 - Uploaded by M. Pierce
oil pan had a small rust hole after the rebuild 5 years ago found a pan so ... 1958 Chevrolet Del Ray - Nice Cruiser - Beautiful New Interior ...
Tensioner pulleys are designed to be 'Self Adjusting'. These pulleys are on spring loaded arms so they automatically push against the belt keeping it tight. You use a socket or a spanner to swing the pulley arm back against this spring.
*Note* This is a powerful spring so BE CAREFUL when your working on it!
A lot of these tensioners have two small holes to help with installing a belt. When you swing the tensioner arm back these two holes line up with each other. You can then slide a hex key, or something similar, through both holes and it holds the arm back giving you space to get the belt on.
*Caution* When your ready to release the tensioner DO NOT just pull the hex key out!! With the socket or spanner you used to swing the tensioner arm back push the arm against the spring again, carefully pull the allen key out then Carefully release the pressure on the spring so the pulley sits correctly and tensions the belt.
check the abs system for relay and electrical problems
the clicking can be from a cycling relay and the head lights flickering from the power draw for the abs away from the head lights.
The reverse wire on the car audio harness for a 2006 Chevrolet Silverado is yellow. If you're connecting an aftermarket stereo, this wire is used to trigger the reverse camera display when you shift into reverse. Make sure to connect it appropriately for your specific installation needs.
I'm guessing you mean knock sensor wire. If you need just the end of the wire you should be able to order a pigtail from any parts store and just but connect it on