20 Most Recent
2010 GMC Terrain Questions & Answers
How can I remove right rear hub assembly?
what is a hub?
is this a brake hub? what?
the service manual covers all that, buy one,. rent it online.
job job told at all brakes , wheel bearing hubs bad.
or emergency brake failures.
axle seals leaks, can we have clue?
what's up doc, what is the problem so we can read he pages in the manual to you.
so I will now guess 1 job of many
bad caliper day, Rf&R
rear
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation.
- Remove the brake hose fitting bolt?(1).
- Remove the brake hose fitting?(2)?from the brake caliper.
- Remove and discard the brake hose fitting gaskets?(3).
- Cap the brake hose fitting to prevent brake fluid loss and contamination.
- Hold the brake caliper guide pin stationary and remove the brake caliper guide pin bolts?(1).
- Remove the brake caliper.
now the rotor
- Remove the brake rotor bolt?(1)?and the brake rotor.
- If the brake rotor is difficult to remove, remove the park brake shoe adjuster access plug on the face of the brake rotor to gain access to the park brake adjuster and loosen the park brake shoe adjuster.
just hang the caliper on bailing wire or bungees. not pull hoses !!!!
see magic screw 1, my guess you missed that trick.
2010 GMC TERRAIN C0545 , power steering not working
DTC C0545 00: Steering Wheel Torque Input Sensor
You need service repair info. for diagnostic testing for code co545.
Circuit/System Description
The power steering control module (PSCM) continuously monitors the torque sensor input and output shaft sine wave frequency signals. As the steering wheel is turned and torsional twist is applied to the steering column shaft, the torque sensors input and output shaft sine wave frequency signals are processed by the PSCM to detect and calculate the steering torque.
Conditions for Setting the DTC
The PSCM detects open, short to ground or short between any of the torque sensor circuits.
Actions Taken When DTC Sets
• DTC C0545 is stored in memory.
• The driver information center (DIC) displays the SERVICE POWER STEERING warning message.
• No steering assist.
GMC 2010 Terrain grease fittings
There are no grease fittings on the 2010 GMC Terrain.
The only items you can apply a thin film of white spray lithium grease are the door, hood and rear hatch hinges.
A fast blinking directional signal
This indicates a bad bulb. Just walk around the outside of the vehicle while it's in the turn signal flash mode and observe which bulb is not flashing-replace bulb.
No trans dipstick on 2010 terrain slt 2.4Litre
Automatic Transmission Fluid Section 9-13 of Owner's ManualHow to Check AutomaticTransmission FluidIt is not necessary to checkthe transmission fluid level.A transmission fluid leak is theonly reason for fluid loss. If a leakoccurs, take the vehicle to yourdealer/retailer service departmentand have it repaired as soon aspossible.There is a special procedure forchecking and changing thetransmission fluid. Because thisprocedure is difficult, this should bedone at your dealer/retailer servicedepartment. Contact your dealer/retailer for additional information orthe procedure can be found in theservice manual.
Replace rear wiper
Lift up on the wiper assembly and slide the wiper blade off.
You will find there is no aftermarket blade refill that fits the 2010 Terrain. You will have to settle for a 12" refill.
Not finding what you are looking for?