2007 Chrysler Town and Country - Answered Questions & Fixed issues


Yes take to a shop and have the fault codes read to see what part of the system is malfunctioning.

2007 Chrysler... | Answered on Feb 14, 2017 | 70 views


You gave two different codes.

P0531: A/C Refrigerant Pressure Sensor Circuit Range/Performance
http://www.autocodes.com/p0531_chrysler.html

P0513: Incorrect Immobilizer Key
P0513 Dodge Incorrect Immobilizer Key

2007 Chrysler... | Answered on Nov 03, 2016 | 166 views


Cable inside door came off or broke or at the lower latch

2007 Chrysler... | Answered on Sep 07, 2016 | 49 views


The Internet, though, has a large number of web sites where
you can buy service manuals and schematics from bookstores,
publishers, and other collectors. Here is just a sampling of
what sites are out there:

Factory Automanuals
http://www.factoryautomanuals.com/
search for : factory service auto repair manuals

about Chilton Repair Manuals
http://www.chilton.cengage.com/

about Haynes Repair Manuals
Haynes Publishing
Haynes auto manuals
http://www.haynes.com/


Vintage Books
Vintage books com Rare used and out of print books
http://www.vintage-books.com/

AutoLit
http://www.autolit.com/home.htm

2007 Chrysler... | Answered on Jan 23, 2016 | 149 views


2007 Chrysler Town and Country

Get your car fix right now :))

2007 Chrysler... | Answered on Jan 11, 2016 | 205 views


Bad wheel sensor. Have the codes read to see which one.

2007 Chrysler... | Answered on Sep 07, 2015 | 100 views


It will not be the caliper burning.... If anything suspect the brake pads. There could be a few problems causing this. Upon installation, were the pads and slide assemblies cleaned and lubricated with synthetic brake grease? If not the pads may be sticking due to lack of lubrication. If lubrication was applied, there may have been some on the pad material and this is what is causing the burning smell. Did the calipers push back easily for installation of the pads or were they stiff? All these points can contribute to a hot smoking brake.

2007 Chrysler... | Answered on Jul 19, 2015 | 173 views


1st thing you need to do is run a fault code scan. But a guess would be that the idle speed control valve is either defective or sludged up and is not able to control idle speed. Do the following to clean the IAC valve.

2007 Chrysler... | Answered on Jun 27, 2014 | 64 views


Hello Amber
it needs service? Im sure.
Your car has and engine brain that works overtime, to stop all stalls.
in fact is amazing doing that, unlike cars of old with carbs.
so what is wrong, well.
there can be 4 things .
1: bad engine (lost compression.) tools
2: bad spark , never tuned up> by the book?
3: bad fueling
4: lost 12vdc power (battery is low,) (and friends) this is #1 really , im backwards.
your service tech does all 4, and finds true cause,most time.
there are always exceptions with the crazy complexity today.
good luck.

top free test

can you save the stall with a happy right foot.????????????

2007 Chrysler... | Answered on Jun 27, 2014 | 59 views


moved you out of computers, to Chrysler Town and Country


the cars service manual covers this and varies by engine, and drive train on all cars made these rules.
RTM
read the cars, factory service manual.

Chrysler Town... | Answered on Apr 26, 2019 | 16 views


  • Open fuse
  • Defective speed sensor

Chrysler Town... | Answered on Mar 27, 2019 | 28 views


Your brake light switch has one wire for tail lamp and another to your computer to inform your computer that you are stepping on the brake pedal .
This type of problem can be diagnosed with a scan tool .
Good Luck

Chrysler Town... | Answered on Mar 02, 2019 | 30 views


The radiator fan relay is located behind the grill on the driver's side of the vehicle. There is no relay in the distribution box. There is a 40 amp fusible link, however, in that box.
The relay (behind the grill) works in conjunction with the coolant temperature sensor, the A/C high pressure switch, the transmission temperature sender and the PCM. This relay will run the fans from 30% to 99% of full speed based on the signal coming from the PCM. This is all according to the official Chrysler shop manuals that I have for my 2005 Town and Country van.

Chrysler Town... | Answered on Nov 15, 2018 | 6,606 views


Can you repeat this brake failure while parked and wheels off the ground? In what way does the front left brake lock up? Is the brakes dragging on its own or does it lock up as soon as you touch the brake pedal? With the vehicle raised, will the brake lock up with it in park and the van is running? Can you confirm that the only time the brake locks up is on short or long trips? You may need to send the van in for diagnostics. You may want to contact your local dealer and ask if there is a Recall, TSB or campaign for this issue. You will need to narrow down your search and see if maybe it is something you missed. From your description I might look for debris in the line somewhere between the ABS module and the front left brake caliper. Remove, isolate, and blow out the suspected line, at both ends. I doubt it applies to you but to be thorough. Did you check to see if the brake pads were contaminated with oil or grease? Are both sides of the brake rotor clean and free of defects? Are any brake warning lights on? You may want to see if any codes were stored in the ABS module. Please write back with any questions or new information.
Good Luck.

Chrysler Town... | Answered on Oct 06, 2018 | 32 views


I found a method to determine calibration issues with actuator mechanisms that may be of help with your T & C -


2003 Chrysler Town Country Blend Door Actuator Locations

Chrysler Town... | Answered on Oct 03, 2018 | 74 views


It is where the air goes into the engine from the air cleaner hose.

Chrysler Town... | Answered on Apr 19, 2018 | 51 views


If you are inclined you can do this. part is about $250-$300. here is just one of many vendors.
Totally Integrated Power Modules TIPM

Chrysler Town... | Answered on Mar 19, 2018 | 27 views


There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, troubleshooting owner's/service/repair/parts/maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

Chrysler Town... | Answered on Mar 18, 2018 | 76 views

Not finding what you are looking for?
2007 Chrysler Town and Country Logo

22 questions posted

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

Marvin
Marvin

Level 3 Expert

85108 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...