20 Most Recent
Questions & Answers
2008 town and country po339
That code could be from bad plugs. There is a chance that the wires to the plug are bad and also the wires to the crank sensor could be having problems. Keep in mind that the crank sensor has another part on the crank shaft that can have problems too.
on Mar 27, 2015
Radiator fans don`t work on town and country van causing engine to overheat
The radiator fan relay is located behind the grill on the driver's side of the vehicle. There is no relay in the distribution box. There is a 40 amp fusible link, however, in that box.
The relay (behind the grill) works in conjunction with the coolant temperature sensor, the A/C high pressure switch, the transmission temperature sender and the PCM. This relay will run the fans from 30% to 99% of full speed based on the signal coming from the PCM. This is all according to the official Chrysler shop manuals that I have for my 2005 Town and Country van.
on Nov 15, 2018
2003 town and country van the front left brake locks up while driving a short distance or longer and the steering wheel is hard to control.
Can you repeat this brake failure while parked and wheels off the ground? In what way does the front left brake lock up? Is the brakes dragging on its own or does it lock up as soon as you touch the brake pedal? With the vehicle raised, will the brake lock up with it in park and the van is running? Can you confirm that the only time the brake locks up is on short or long trips? You may need to send the van in for diagnostics. You may want to contact your local dealer and ask if there is a Recall, TSB or campaign for this issue. You will need to narrow down your search and see if maybe it is something you missed. From your description I might look for debris in the line somewhere between the ABS module and the front left brake caliper. Remove, isolate, and blow out the suspected line, at both ends. I doubt it applies to you but to be thorough. Did you check to see if the brake pads were contaminated with oil or grease? Are both sides of the brake rotor clean and free of defects? Are any brake warning lights on? You may want to see if any codes were stored in the ABS module. Please write back with any questions or new information.
on Oct 06, 2018
Not finding what you are looking for?