Dodge Durango - Recent Questions, Troubleshooting & Support

Your best bet , take it to a qualified repair shop . The New BCM you put in ,you did it ,or a qualified repair shop ? Has to be programmed for the anti-theft system key codes .

2001 Dodge... | Answered on May 19, 2019

  • 2005 Dodge Durango Car Radio Stereo Audio Wiring Diagram
  1. Car Radio Constant 12v+ Wire: Gray/Red
  2. Car Radio Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox for switched power.
  3. Car Radio Ground Wire: Black
  4. Car Radio Illumination Wire: Black/Yellow
  5. Car Stereo Dimmer Wire: Orange
  6. Car Stereo Antenna Trigger: N/A
  7. Car Stereo Amp Trigger Wire: N/A
  8. Car Stereo Amplifier Location: N/A
  9. Car Audio Front Speakers Size: N/A
  10. Car Audio Front Speakers Location: N/A
  11. Left Front Speaker Positive Wire (+): Dark Green
  12. Left Front Speaker Negative Wire (-): Brown/Red
  13. Right Front Speaker Positive Wire (+): Brown/Yellow
  14. Right Front Speaker Negative Wire (-): Brown/Light Blue
  15. Car Audio Rear Speakers Size: N/A
  16. Car Audio Rear Speakers Location: N/A
  17. Left Rear Speaker Positive Wire (+): White
  18. Left Rear Speaker Negative Wire (-): Dark Blue/Red
  19. Right Rear Speaker Positive Wire (+): Brown/White
  20. Right Rear Speaker Negative Wire (-): Brown/Orange

regards, Tony

Dodge Durango... | Answered on May 08, 2019

Your vehicle owners manual should you what these fuse control. If you need one, check this site.

2001 Dodge... | Answered on Apr 29, 2019

Possibly broken wires or burned fuse. Check wiring above accelerator pedal. Check engine control fuses. Also check wiring near injector pump and throttle--top of engine.

2003 Dodge... | Answered on Apr 29, 2019

I think you have air in the anti-lock module (ebcm). Power bleeding will clear the air out, but costs $$ . If you have time try this. Keep an eye on the fluid level or better yet have someone help, loosen all the bleeders until they just drip let them drip until you've used a pint of fluid then tighten the bleeders and see how it feels if there are bleeders on the anti-lock unit do this separately. If this fails you'll have to get to a shop with a pressure bleeder. I hope this helps. Take care.

Dodge Durango... | Answered on Apr 27, 2019

I own a 04 durango and the door lock actuator froze up internally and I could not open the rear hatch. After hours of research on my computer nothing seemed to fix the problem. I eventually figured it out myself. You must pull the screws out of the molding on the inside of the rear door. You can now pull the molding toward you and look down at the actuator and latch. You can pull on the molding quite a bit if necessary. I never broke mine and I was pretty agressive with it. Now, on top of the whole mechanism is the lock actuator. There should be a white plastic lever sticking out towards the driver side. If you can slide it from back to forward "forward is front of vehicle", the lock should be working. If not your door is not unlocking. My durango had 3 Torx screws on top of the actuator. Remove them. This will take the actuator off of the latch. Now that the actuator is not binding or holding the lock from moving, again try to move the white plastic lever towards front of vehicle. It should click and you should be able to open the door.

2004 Dodge... | Answered on Apr 26, 2019

I take help from online websites that have this service like helping in repair some like reliable-store have instant help.. others are a bit slow which I don't prefer.. . rest is up to u.. U can also get free manuals

2002 Dodge... | Answered on Apr 12, 2019

This video is for a Dodge pu but should be the same as a durango 5.7 engine

Dodge Durango... | Answered on Apr 08, 2019

The diagram is for headlamps, The top wire to headlamps in diagram is voltage, fuse protected and hot all the time. On/off--hi/lo beams are controlled on the headlamp ground circuit, bottom wire coming from headlamps in diagram. The dimmer and headlamp switch are part of the headlamp ground circuit.

2000 Dodge... | Answered on Apr 06, 2019

Hi there's this website something like reliable-store and it is very amazing for manual for repairing servicing anything
someone on fixya recommended it to me and I thank him even today
They have full manuals and it's verrrrry cheap and mine
I got free in offers
3rd time I bought it, I also had an issue with the file so the girl replaced it in 30 mins
there is one website more but i don't remember its name it was 2 years back bitman something link this
Try these out brother

2004 Dodge... | Answered on Apr 04, 2019

This is for a newer model but should give you an idea of what to do.

Dodge Durango... | Answered on Mar 22, 2019

There should be 2 wires connected to the defrost element. You will need a meter which measures 12 volt DC. When you turn on the defrost, it should measure 12 volts DC across these 2 wires. If there is no voltage, you have a power supply fault. Broken wire of switch. If voltage is there, then there will be a break in the defrost element. These can be repaired. There is a special type of glue / repair kit that can be purchased from most Auto part stores.

Dodge Durango... | Answered on Mar 22, 2019

Not finding what you are looking for?

-5,788 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Dodge Durango
1999 Dodge Durango

-935 Questions

2000 Dodge Durango
2000 Dodge Durango

1,576 Questions

2001 Dodge Durango
2001 Dodge Durango

1,339 Questions

2002 Dodge Durango
2002 Dodge Durango

852 Questions

2004 Dodge Durango
2004 Dodge Durango

967 Questions

Top Dodge Experts


Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dodge Cars & Trucks

  • Forum

View Most Popular

  • Dodge Cars & Trucks