ATVs - Page 8 - Recent Questions, Troubleshooting & Support


check the shift rod from the shift box going to the back to the transmission for being bent

Polaris ATV | Answered on Nov 06, 2017


it will be two things, 1st float level in carb adjusted wrong, or the rev limiter is bad

Polaris ATV | Answered on Nov 06, 2017


Hi the cable needs slack if you take all the adjust out meaning the is no free play in the cable your taking the pressure off of the clutch plates causing it to not be engauged.

Yamaha 2005... | Answered on Nov 06, 2017


First question since i am assuming it was just sitting around for some time if i am correct you need to pull the carb remove the float bowl and components if everything was done correctly with your rebuild the likely problem is your carb is gummed up remove everything in the carb low speed jet etc. soak everything in sea foam fuel cleaner overnight and hopefully you have some compressed air and blow out that low speed jet and passage way pay close attention that you have see fluid coming from the other end and check the jet make sure it is unclogged hold it up to the light.

Polaris ATV | Answered on Nov 06, 2017


your shift linkage could be out of adjustment. the two rods that run to your transmission. try disconnecting one and see if it shift *(without the engine running), then do the same thing for the other. if it shift into high without the low gear shift linkage disconnected, then they are out of adjustment.

ATVs | Answered on Nov 05, 2017


Yes it is a low oil sensor / switch. It could be faulty, but it can be bypassed by disconnecting it. I would check all of your wire connections from your stator to your ignition switch..

Honda 2004... | Answered on Nov 04, 2017


Go to school and learn. Nothing to do with ATVs!!!!!!!!

ATVs | Answered on Nov 04, 2017


doesn't the neutral safety switch open that circuit so you can't start the thing accidentally? if so then i would think you should not any power from the switch when in neutral.

ATVs | Answered on Nov 02, 2017


twinkle lights and engine runs fine , it's not going to hurt you. So says the dealer

Polaris ATV | Answered on Nov 02, 2017


hi.
this is all i can find on the internet about it.
Where to find serial number on Polaris Ranger? Whenever corresponding about a Polaris RANGER utility vehicle, be sure to refer to the vehicle identification number (VIN) and the engine model number and serial number. The VIN can be found stamped on the lower frame rail on the front LH side of the vehicle (see Figure 1-1).

2011-2012 RANGER 800 XP / HD / CREW / 6x6 Chapter 1 - Asap911

asap911.com/wp-content/uploads/2012/.../2012-Polaris-Service-Manual-Chapter_01.pdf Search for: Where to find serial number on Polaris Ranger?.

how to find vin number on polaris ranger Google Search

ATVs | Answered on Oct 31, 2017


Most likely the head gasket is leaking. As to parts we do not have parts here or anyway to look them up for you.

ATVs | Answered on Oct 30, 2017

Not finding what you are looking for?
ATVs Logo

7,758 questions posted

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

12650 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

 Scott Tx
Scott Tx

Level 2 Expert

552 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...