Question about RTO Quads 125cc Full Size Adult 4 Wheelers ATV

1 Answer

110 panther not starting gas is good spark good . it will only fire when i spray ether in the carb ,cleaned carb float working rite but will not start what can i do and what is the gap on the plug?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Prodigy:

    An expert who has answered 500 questions.

  • Expert
  • 523 Answers

Check your compression

Posted on Mar 12, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
pamelakeenan
  • 33 Answers

SOURCE: I have a panther 110cc that is getting gas, has

sound like you may need the plugs cleaned see a mechanic

Posted on Sep 29, 2009

  • 11 Answers

SOURCE: grizzly 660 will not start

Did you check the resistance on the stator? the stators are known to go out on the rhinos!

Posted on Dec 20, 2009

  • 5520 Answers

SOURCE: Massey Ferg 24 won't start. Spark to plugs, firing

Lots to check for small engine. First, have Starter draw checked for spinning Voltage draw. May be turning below what is needed to get engine going. Check compression specs. 60 sounds better than 30, most engines should not be more than 10% different in cylinder to cylinder compression. Spray small amount of 30W oil in each cylinder to determine if compression changes. Rings at fault if it does help, valves at fault if it does not.

Did it fire with ether? Should have run for a couple of seconds with ether. The valve timing is important and you need to adjust the valves to insure best compression. Even if you have Specs to adjust a warm engine, you need to be close on a cold engine. Don't remember if Fergusons had optional adjustable lifters like Fords.

Bad coil? They can be bench checked. Check also with hot wire to coil disconnected if your switch is letting power go to coil in RUN position.
Check your Cam timing and distributor as well as the capacitor inside the Distributor. Firing order?

Posted on Jan 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Polaris phoenix 200, has new fuel cleaned carb,good blue spark,fires don't start or run,plug lil wet but not flooded or soaked


If you have spark at the right time, fuel, air.... you might try a spray of staring fluid. I would then check the compression. If it is too low it will not start.

Mar 31, 2017 | Polaris ATV

2 Answers

What should I check to repair this problem? Vehicle has spark and gass flow, but will not fire.


that leaves compression

or coil....can be ok when cold fails when hot

rings worn or valve clearance to check

Oct 12, 2016 | ATVs

3 Answers

Why won't it idle without choke?


Fuel supply problem somewhere. How is the float adjustment and the float valve? I'd guess the level adjustment is too low.

Mar 28, 2015 | Honda 2005 TRX 400EX

1 Answer

How do I clean a carburetor on a 110 ATV panther


check youtube for generic carb cleaning videos. they're usually all similar and you'll get the jist of it.

Oct 20, 2014 | ATVs

1 Answer

90cc quad chinese wont fire. New battery cleaned the carb the 2 jets and the little one that is on the float. Compression is fine and spark is fine. It cranks and cranks but will not start. So its getting...


just for fun, while you're cranking it put your hand over the intake of the carb completely covering it and see if your hand gets wet with gas. this might even start it too.

Jul 17, 2017 | ATVs

3 Answers

I can't get my atv to start it turns the spark plug is firing and the gas is flowing but it will'nt start


check the compression, REPLACE the spark plug with a new one, clean or have the carb professionally cleaned. compression should be at least or more than 100-110 lbs.

May 22, 2014 | ATVs

1 Answer

When I try starting it some times it will start other times it wont


If it turns over quickly, ... does the spark plug fire?,..put in new, correct NGK plug to begin, then make sure you have gas going to the carb, then see if gas flows out of the carb drain, (straight head screw)... gas should flow out freely. If its been sitting,, may need a carb cleaning...JUST CLEANING...NOT "rebuilt"...

Apr 06, 2014 | ATVs

1 Answer

It turns over, new battery. It's getting gas to the carb but won't start. Side note, when I spray starter fluid into the airway to the carb and cover the airway so it can **** in some of it then I let


When you cover the intake on the carb you are causing the engine vacuum to draw too much gas take the carb off and check the float and the jets,

Jul 15, 2013 | ATVs

1 Answer

Why wont my 110 cc pocket rocket start has spark light compression


air filter is clogged or you need to clean the carb make sure you have good carb compression and that your gas is running threw the lines properly

Jan 19, 2013 | RTO Quads 125cc Full Size Adult 4 Wheelers...

1 Answer

My 05 Yamaha Grizzly 660 will not start. In my limited troublshooting practice I looked at FUEL, FIRE and AIR. Here is the fault, the engine will not start. I checked wires/fuses, plugs, fuel lines and air...


Sounds like you have a stuck float needle in the carbs (2). Usually after a few days with gas in the carb they will free up, you could 'knock' on the carbs with the plastic end of a screwdriver to help free them up. If not, turn off fuel, drain the carbs and fill them with carb cleaner for 24 hours. Redrain, attach fuel lines and turn the gas back on. If still no start it's time for a rebuild...

Mar 05, 2017 | Yamaha 2005 Grizzly 660 Auto 4x4

Not finding what you are looking for?
RTO Quads 125cc Full Size Adult 4 Wheelers ATV Logo

Related Topics:

604 people viewed this question

Ask a Question

Usually answered in minutes!

Top RTO ATVs Experts

fordexpert

Level 3 Expert

5520 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

relojmesa

Level 2 Expert

84 Answers

Are you a RTO ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...