Question about Yamaha 2004 Blaster Base

Open Question

My blaster cranks and runs but it wont go full throttle could u tell me wat the problem could be?

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2000 Yamaha blaster 200 runs good at half throttle but bogs after half throttle


check for air leaks around the air filter and/or clean the carb

Dec 09, 2016 | ATVs

1 Answer

My tomahawk 110 atv will not start. I have rebuilt carb , replaced spark plug and it cranked and ran fine until I opened it full throttle and then it started sputtering and diedand now Iit will not re


You need three things to make any gas engine run, in this order double check make sure you have proper timing set, spark and fuel. Could be bad gas or a bad ground from motor to frame.

Dec 02, 2014 | ATVs

1 Answer

Howdy.I have a 2005 yamaha blaster.Low hours,good spark and freesh fuel.Fired it up the other day and was fine for about 5 min.Then it seemed to loose power then died.I checked fo fuel and spark , bot


the crankcase is filled with fuel from a leaking carburetor float (would be LOTSSSSS of smoke) OR Bad crankcase seal and its sucking in air, bad reed cage area seal, exhaust plugged up!

May 05, 2014 | Yamaha 2005 Blaster Base

1 Answer

Loses power full throttle


does it have gas
is the fuel turned on
does it have spark
is the battery good
does it crank
you have to try a little harder to get proper help !!!

Dec 30, 2013 | RTO ATVs

1 Answer

My blaster runs good but once it gets hot it revs up and wont stop i cant stop it with the run switch or the key i block the air to turn it off i put a new plug in it it has the oil pump off i mix the gas...


Sounds like an air leak... either at the base gasket or the reed valve gasket. or the carb/reed intake boot...MAYBE THE HEAD GASKET...

...AND ... get a qualified pro to look at your carb..tell him which parts you replaced...

Aug 06, 2017 | Yamaha 2004 Blaster Base

1 Answer

Blaster stuck on full throttle


I would check the plastic heat isolator between the carb and cylinder head for leak.

Jul 07, 2013 | Yamaha 2004 Blaster Base

1 Answer

2006 yamaha blaster 250


is it getting spark? did you check the compression?

Jun 17, 2012 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

Yahama blaster cut out at full speed, will not start


Very vague question but I will try anyway if it died at full throttle and won't start again check the copression if it is below 90 psi it needs the top end rebuilt also when u pull the spark plug out look at it if it is whitish and dry definitely needs to be rebuilt running to lean if compression is good carb or electrical problem hope this helps you

Aug 29, 2010 | RTO Quads 125cc Full Size Adult 4 Wheelers...

2 Answers

1989 yamaha blaster does not stay on


mcdevito75 here, Sounds like a lack of spark to the spark plugs to me, have a shop check it out for you, menwhlie you can check all around your Yamaha blaster for any wires loose or not connected.

May 24, 2010 | RTO 200cc Full Size Four Wheeler ATV

Not finding what you are looking for?
Yamaha 2004 Blaster Base Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha ATVs Experts

 Scott Tx
Scott Tx

Level 2 Expert

537 Answers

Wayne McNeil

Level 2 Expert

168 Answers

yadayada
yadayada

Level 3 Expert

76630 Answers

Are you a Yamaha ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...