Question about ATVs

Open Question

My model is a klf250 workhorse 4 wheeler. i miss placed the start key and replacced barrow with a switch.i then found key and when i rewired the barrow it sparked and lost all power.i guess i have blown a fuse.if so where are they or do you think it would be somthing else.any advise would be great.thanks kind regards aj

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
IB4G2008
  • 3587 Answers

SOURCE: Bosch Washing machine WFB 4001

well, seems to me that you are using too much juice for the circuit, which implies a SERIOUS issue with the machine. perhaps the motor is locked, or something in control panel is shorted out?

Posted on Feb 27, 2008

Ad
  • 2 Answers

SOURCE: brake lights

I own a 1995 Cutlass Supreme and had the SAME EXACT problem a few years ago. I had several people look at the problem until I finally figured it out...

The trouble is that there's a faulty turn signal switch. I know it sounds weird but I guess the circuits for the brake lights (not the third-center-light) runs through the turn signal switch. Replace this and you should be fine.

Posted on Aug 27, 2008

  • 1 Answer

SOURCE: 4 wheeler won't start

The Sunl's are notorious for the stator going out. Check with your dealer for specs on testing the stator. It could also be the CDI unit too! I hope this helps

Posted on Aug 28, 2008

  • 2 Answers

SOURCE: my 4-wheeler idles fine but misfires once you give it gas

I don't know if I can solve it but it sounds to me like you're not getting enough fuel. has it been sitting awhile or just start doing this randomly? If it's been sitting there's a pretty good chance you'll need to clean you carburetor. when gas sits in the bowl of your carburetor for too long it will get thick and smell almost like varnish. My Suzuki 250 4x4 had a similar misfire and cleaning the carb fixed mine.

Posted on May 17, 2009

  • 123 Answers

SOURCE: I have a 1996 honda shadow ace vt1100c2. I just

Either that or the relay that connects the positive lead to the starter is shorted. If you can get into the relay, you may be able to hold the contacts open if the switch is shorted or the contacts may have welded themselves together

Posted on Jul 15, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I lost my keys to my 2011 Honda rancher 4-wheeler. I need the # off the ignition switch but I don't kmow where it is


you mean number on the ignition barrel
for the key code number

if not found near the key insertion point

honda ATV dealer or lock smith can help
remove the.....ignition, loom , barrel
take that to them




26301156-vpuqtjtdvoowntuyvcl35auo-4-0.jpg

Oct 04, 2016 | ATVs

1 Answer

Why wont my rubica 4 wheeler go in reversa


If you have a Honda Rubicon, you must place the transmission in Neutral, then pull in Left Hand brake and push down Reverse knob that will remove the reverse lockout and allow you to shift it into reverse. If that doesn't work your reverse lockout knob might be defective or out of adjustment. The adjuster, depending on which model you have, will be on one end of the reverse lockout cable.

Jul 02, 2014 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

How to start a four wheeler without a key?


Hey,
You are venturing into an area that will cause more problems in the long run. If the ATV is actually yours, take it to a dealer and they can get you a key, or.. you can take it to a quality reputable locksmith shop and they can make you a key.
Please do not start cutting and rewiring.. it only leads to more problems!!

Jun 05, 2014 | Honda 2005 FourTrax Rancher AT

1 Answer

4 wheeler ignition replacement


what kind of atv are you working on?

Jan 18, 2014 | ATVs

1 Answer

I need to install a key ignition switch on 4 wheeler


unscrew and unplug old one, reverse to install new one.

Jan 18, 2014 | ATVs

1 Answer

Taotao 125cc


i think we can all say on here take to your local bike shop have that auto start ripped out and have them put in a key if worrying bout it getting stolen chain the thing down
also the key fob is a magnetic sensor loose connections

Sep 15, 2013 | ATVs

1 Answer

Atv removing ignition


go to ebay and find a new switch, it'll come with a new key and should plug into a wiring harness.

Aug 29, 2012 | RTO Quads 125cc Full Size Adult 4 Wheelers...

1 Answer

My chinese 4 wheeler wont start the motor drags when i push the starter but tho start it


check battery u may need a jump or the oil is too cold and 4 wheeler needs to sit in a warm place for a hr or 2

Apr 19, 2010 | RTO Quads 125cc Full Size Adult 4 Wheelers...

9 Answers

How do I start my sons atv without the key(hotwire)


Simply unplug the key switch you might find the electric start works too if not should start by hand of coast start every 4 wheeler I can ever remember always started this way hope that helps good luck

Mar 26, 2009 | RTO 125cc Full Size Adult Quad ATV

Not finding what you are looking for?
ATVs Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

15314 Answers

yadayada
yadayada

Level 3 Expert

80417 Answers

 Scott Tx
Scott Tx

Level 2 Expert

598 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...