Question about Polaris ATV

1 Answer

My polairs 360 is laying on its side (the side with 2 wheels) trying to run

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 640 Answers

Make sure that the bag is not full. It could be weighing down the automatic pool cleaner on one side. Remove the float head and shake it. If you hear water, it needs to be replaced. Make sure that the feed hose if floating evenly on the pool's surface and adjust the hose if necessary.

Posted on Feb 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2008 Kawasaki 360 , automatic quad . It starts up first time, ideals OK and dies after two minutes of running,. Checked carb , fuel filter, air filter, it's still doing it, can anyone advise please .


sounds like fuel flow from the tank is having trouble and its running off the gas built up in the bowl. could be the petcock, tank strainer, tank vent clogged

Feb 14, 2017 | kawasaki 2008 Prairie 360

2 Answers

Is therea way to add back up lights on a 2013 polairs ranger 900xp


I would think it is possible with a little wiring ingenuity. You could either wire them into a rocket switch mounted on the plastics somewhere that you could manually turn on when going to back up.

Or, if you could fabricate a mount for a push button style switch, that could mount on the shifter that when you shift it to reverse would push the button in supplying power to the light, and shut off when shifting out of reverse.

Aug 22, 2016 | Polaris ATV

1 Answer

Why is my front driver side tire binding in 2 wheel drive


Probably dirt or grit got in to your CV joint check cv joint for tear or small rip

Feb 01, 2016 | Polaris 2014 RZR 4 900 EPS Orange Madness...

1 Answer

Will idle & run at slow speeds, bogs down at higher speed.


Prairie 360 revs high but goes slow (45mph) - Kawasaki ATV Forum

www.kawieriders.com > ... > Kawasaki Brute Force/Prairie/Bayou
Oct 27, 2008 - 2006 Prairie 360, wife's ride, polar white, with 26" Swamp Lites on SS108's. ... that it has a low top-speed...45mph is about as fast as they seem to go. ....air cooled motor theres no real performance there, the P360 wts are light ... Can't put 2005 Kawasaki KVF 360 into gear
Jun 30, 2013
Prairie 360 speed/power issue?
Aug 28, 2012
06 Prairie 360, too many rpms???
Nov 30, 2011
2004 Prairie 360: WOT miss
Nov 9, 2011
More results from www.kawieriders.com

Oct 08, 2015 | kawasaki 2005 Prairie 360

2 Answers

How do I fix my front wheel drive system on my 2004 ATV 400 Sportsman Late model? After extensive work and parts replacement my all wheel drive is not working.


Just a suggestion but you should consider soldering all your electrical connections to insure they are weather and vibration proof. Additionally, I added a small 3 amp circuit breaker, but a 1.5 to 2 Amp automotive fuse and fuse holder will do nicely.

Process:

1- Disassemble the 'Instrument/Light' cluster cover.

2- Remove the 'Radiator access' panel.

>>>Perform This Test BEFORE Proceeding and make SURE all power is OFF!<<<

3-On the drivers LEFT side of the radiator access area, locate two (2) connectors, each with SOLID GREY wires and BROWN wires with a WHITE Stripe on top and smaller diameter Solid Grey and Brown wires with a White stripe leading down.
--a) Disconnect both connectors by pulling the top and bottom sections away from each other. (DO NOT pull the WIRES, use the connector body to pull).
--b) Test EACH of the two (2) connectors with the SMALL DIAMETER wires leading down. (see Hub Coil Connectors pix)
--c) Using an OHM meter, measure the resistance across the two pins (one connector at a time) for each connector. Depending on the accuracy and sensitivity of the meter, each connector should read between 25 and 28 OHMS. NOTE: If EITHER of the two (2) Hub Coils reads ZERO (0) or less than 25 or Greater than 28 OHMS STOP!!! The Hub Coil itself OR the wires OR the connectors may be defective or in need of repair!
--d) Using an OHM meter, on EACH of the two connectors, measure the resistance between one pin of each connector and GROUND (any bare metal point on the ATV frame). NOTE: If EITHER of the two (2) connectors resistance to GROUND reads anything GREATER/ABOVE than ZERO ( 0 ) OHMS STOP!!! The Hub Coil itself OR the wires OR the connectors may be defective or in need of repair!

>>>If the test in 'c)' or 'd)' FAIL STOP, DO NOT proceed!! The Hub Coil itself OR the wires OR the connectors may be defective and MUST be repaired before ANYTHING else is done!<<<

4-(For my model) On the right handlebar, check the lamp in the AWD switch to make sure it is not burned out or missing. Replace lamp if necessary. (Not essential to the AWD operation, just nice to have to confirm voltage is being applied to the front wheel Hub Coils)

5-In the 'Radiator Access' area, locate the Red/White stripe wires providing (switched) full time + (battery plus) voltage (accessory power) via a ¼" female connector. "Accessory Leads" - in the wiring diagram.

6-Using a volt meter (or continuity light), CONFIRM that the terminal is OFF (NO voltage) when the ignition switch and the 'Engine STOP/START switch (on the left handlebar) are both OFF, and has + (positive) battery voltage, when the ignition switch and 'Engine STOP/START switch are both ON, with the engine NOT running.

Jan 15, 2015 | Polaris 2004 Sportsman 400

1 Answer

Polairs atv 98 mangum 425 4x4 no spark until turn key off


ignition coil failure - not grounded correctly - earth lead failure

Nov 11, 2014 | ATVs

1 Answer

4 wheel drive light flashing on 2008 kawasaki prairie. What does this mean?


Depending on the flashing frequency, it could be the Electronic BRake controller, the 4x4 actuator or the brain.

Look for the service manual online, it has a procedure for checking/cleaning the actuator. It could be stuck with dirt and need a cleaning.

Aug 10, 2014 | kawasaki 2008 Prairie 360 4x4

1 Answer

2006 kawasaki prairie 4x4 model kvf 360 c belt indicator light reset


On the right hand side of the ATV just under the gear leaver, you will find a grey and black multiplugs, you will need to swap them. Please see the link below. KAWASAKI 360 PRAIRIE BELT RESET

Sep 23, 2013 | kawasaki 2012 Prairie 360 4x4

1 Answer

4 wheel drive locks in one side one side will not some times makes a sound to if 2 sides are in


Model? If you put it in regular 4WD it will usually only spin one tire. If you have diff lock and use it, it locks both front wheels but can be hard on front end parts. The front end will do some clanking and popping because it doesn\'t really like diff lock.

Aug 25, 2013 | ATVs

1 Answer

Disney steerable atv ride-on how can i take the wheels off?


If they used the push on (tap on with hammer?) nuts, you need to cut them off and get replacements as they will deform if you pry them off. Use hacksaw on 2 sides to cut nut sides and preserve axle.

Jun 05, 2013 | ATVs

Not finding what you are looking for?
Polaris ATV Logo

Related Topics:

440 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

10940 Answers

Matt Olenzek
Matt Olenzek

Level 2 Expert

293 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...