Question about RTO 125cc Full Size Adult Quad ATV

1 Answer

I cranked my atv this morning, ran fine. i

I cranked my atv this morning, ran fine. i sprayed engine degreaser on battery to clean up terminals and now it wont do anything. what do i do?

Posted by on

  • Anonymous Mar 22, 2014

    My Tautau 125 ATV will is not getting voltage to the starter. Appears the ignition switch is bad. Need a wiring diagram to check it out.

  • Anonymous Mar 26, 2014

    cranks a long time before it starts good compression all new parts in carb carb is clean

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

Check the fuse

Posted on Jun 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 350L Polaris atv, what is the small tank on left side under gas tank for and what do I put in it


This should be for 2 cycle oil injection , find a owners manual online for proper oil ...

Jun 11, 2017 | ATVs

1 Answer

When I try starting my 2014 Polaris sportmsan 570, I get a code Lo 10.6. Does anyone knows what this means


Is the engine cranking over normally (not sluggish as in flat battery) I am not familiar with the specific codes of your machine however a Lo 10.6 could relate to a bad earth which is causing a volt drop to your coil. Check all earth points for clean contact (units come off of the assembly lines with paint in places that should be clean to accomodate good earths and the only thing that is making the earth sometimes is the thread of the bolt holding the terminal in place.

Apr 07, 2017 | Polaris ATV

1 Answer

Why my won't my 2008 Yamaha Rhino 700 start. Has good battery. Cranks over. No codes. Good spark.


If you are only getting 65lbs of compression, remedying that would be my next move!! .. I have seen some run as low as 85lbs..run very poor too.. but never at 65lbs. You should let the engine turn over for about 5 seconds to get compression level.

Sep 19, 2015 | Yamaha 2008 Rhino 700 FI Auto 4x4 Sport...

1 Answer

Need the correct way to charge battery on honda ranger ATV 2010


Remove the wires from the ATV. Clean the terminals..wire brush.. Charge slowly.. about 2 amps is max... like BBQ.. low and slow!

Now clean ALL the wires that attach to the battery. Use a stiff wire brush or fine cut file(what I use), then GREASE the wire ends and battery terminals when you reassemble. I little goes a long way. I like the terminal spray that Wal-Mart sells along with the terminal felt washers (small black spray can)

Mar 11, 2015 | Honda 2010 FourTrax Rancher 4X4

1 Answer

My tomahawk 110 atv will not start. I have rebuilt carb , replaced spark plug and it cranked and ran fine until I opened it full throttle and then it started sputtering and diedand now Iit will not re


You need three things to make any gas engine run, in this order double check make sure you have proper timing set, spark and fuel. Could be bad gas or a bad ground from motor to frame.

Dec 02, 2014 | ATVs

1 Answer

Artic Cat ATV 366 4x4 auto 2009 will not turn over.Put new battery in for the year ,cleaned all of the terminals ,started up and ran fine.Then I turned on the headlights and lost starting ability.I have...


u must always hav 12.6 v for a coil ignition--u cud hav hurt the alternator - the relay is burnt too probly - the spark area and wiring seems to hav issues--get a clymer manual for detaild engine work--cdi is capacitor discharge ign

Mar 10, 2014 | ATVs

1 Answer

Will act like it wants to start but won't completely turn over have charged the battery up


details my man need details. bike ran before now. ? how long u had it . ? make model and serial # and year please. how olds battery? wires to battery real clean? loose on terminals? corrosion ? help me help you !

Feb 12, 2014 | RTO 125cc Full Size Adult Quad ATV

1 Answer

ATV dead


Have a load test done on the battery as a good battery should be 13.5 volts. There may be a dead cell that is not taking the load. Under crank load the voltage will drop off and there will not be enough current left to run the ignition system. The sprayer will use considerable less current that a starting engine so that is not an indication of a good battery

Jul 17, 2013 | Suzuki 2006 KingQuad 700 4X4

1 Answer

How to take a four wheeler engine apart


got a 150cc marchin atv but it ran 3 or 4 times then it quit working it makes a nois like its about to crank but it aint workin and body out there who can give me any solutions

Sep 15, 2009 | RTO 200cc Full Size Four Wheeler ATV

Not finding what you are looking for?
RTO 125cc Full Size Adult Quad ATV Logo

Related Topics:

650 people viewed this question

Ask a Question

Usually answered in minutes!

Top RTO ATVs Experts

fordexpert

Level 3 Expert

5501 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

relojmesa

Level 2 Expert

84 Answers

Are you a RTO ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...