Question about Yamaha 2005 Kodiak 450 Auto 4x4

Open Question

Kodiak 450 replaced ecm but still blowing fuses like it has a dead short. but there are no earths running into it.

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yamaha 450 Kodiak battery not charging, new battery, volt meter not showing any voltage going to the battery


Hi Brian, get a digital volt meter and start the ATV measure the voltage at the battery or at the alternator it should read around 14 volts when charging, if it reads 12 volts the charging system is not working, check or a blown fuse or broken wire, if you can access the alternator directly measure at that point. It takes 14 volt output from the alternator to charge a 12 volt battery

May 06, 2017 | Yamaha 2005 Kodiak 450 Auto 4x4

1 Answer

Yamaha 450 Kodiak battery not charging


its either the voltage regulator (most likely) or the stator. you'll need a service manual to check the stator output.

May 06, 2017 | Yamaha 2005 Kodiak 450 Auto 4x4

1 Answer

Kodiak 450 idling to high to engage gear


turn the idle down? choke could be stuck too.

Jan 05, 2017 | Yamaha 2005 Kodiak 450 Auto 4x4

1 Answer

No spark after started lifting plow


Check fuses first, then go from there to ignition system.

Jan 07, 2016 | Yamaha 2005 Kodiak 450 Auto 4x4

1 Answer

Where is the fuse block on a yamaha Kodiak 450 2005


bet if you look under the seat you might find it .

Sep 27, 2015 | Yamaha 2005 Kodiak 450 Auto 4x4

1 Answer

What would cause my yfz 450 not too have any electric power at all, no lights come on , tried to jump the selanoid n all it does is crank over but doesnt it start??? Any idea why or what the problem is???


There is a good possibility that your main fuse is blown. The main fuse is located on the solenoid. There also should be a spare fuse that is stored on the solenoid, however, if it's blown, something has shorted to cause this, and needs to be found. An important note, if the battery has been hooked up with the polarity reversed, that will blow the main fuse.

There's also a possibility of a bad connection at that fuse, or in the plug that connects the solenoid to the harness. If this is the case, it would just need a little cleaning, or replacement of the whole solenoid.

Oct 29, 2014 | Yamaha 2006 YFZ 450 SE

1 Answer

Yam Kodiak Looses power and won't move


first thoughts is the fuel pump, it might pull the fuel through on tick over but when under load its not pumping hard enough

Apr 26, 2017 | ATVs

Not finding what you are looking for?
Yamaha 2005 Kodiak 450 Auto 4x4 Logo

Related Topics:

77 people viewed this question

Ask a Question

Usually answered in minutes!

Top Yamaha ATVs Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

 Scott Tx
Scott Tx

Level 2 Expert

507 Answers

Noel Bennett

Level 1 Expert

24 Answers

Are you a Yamaha ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...