Question about Suzuki 2005 QuadSport Z400

1 Answer

1994 suzuki quadrunner lt f250 wont run

Been setting cleaned carburetor gravity feeding carburetor tank has holes hekp please. Need serice download pdf free if possibly. Marty

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 3,546 Answers

Hey Marty,
An internal combustion engine requires three things to run..(if all the internals are good)..
1. A properly timed spark.
2. Adequate compression (>120psi).
3. Proper air/fuel mixture.

Start by eliminating one of these at a time...(get a professional to clean and set the carb), install a new spark plug. Get a new fuel line.

Posted on Oct 24, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: question about dual fuel tanks on 83' F250

the switch should be under the radio on the right side of the ac controls its a toggle type switch up and down

Posted on Jan 26, 2009

mxtras
  • 194 Answers

SOURCE: where do all the hoses go to a suzuki quadrunner carb

There is one supply hose (larger) and a bunch of vent tubes. The vent tubes really don't matter how they are connected as long as they vent. The vents that point vertical - just loop the tube up and then down towards the ground.

Posted on Oct 08, 2009

  • 336 Answers

SOURCE: 2003 suzuki rm 85 wont start cleaned carburetor,

if it has reed valves, check them for either cracked or broken pedals. also try starting it with the air filter removed. also make sure the choke is operating properly

Posted on Oct 22, 2009

  • 2 Answers

SOURCE: my suzuki lt 50 wont run under load... rings

9/10 time it is fuel related not enough fuel. Check the screws on the fuel valve if it is too tight it squish the rubber and whola no fuel.

Also try to run it with a bit of choke on, if it runs better then it is fuel starvation.

Posted on Nov 10, 2009

  • 1 Answer

SOURCE: possible carburetor problem? Mower runs for

i have a lt 1000 2005 when i start it with cold engine it boggs for a minute then it starts to run smoothly please help me

Posted on May 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need initial screw settings for a YFM80 Moto 4 carburetor. I just rebuilt it but can't find initial screw settings.


Hey William,
By rebuilt, do you mean the carburetor?? ..or the engine??.. if you rebuilt the carb and you did not remove these screws ( and count the revolutions out from lightly seated), then you did not do the rebuild the carb correctly.. sorry.. What, exactly did you do to the carburetor?? Please reply on here to me..with details!!
thanks..

I cannot understand why someone that claims to have "rebuilt" a carburetor actually missed the BASCIS of carb rebuilding 090.. the air screw (the one on the angle toward the back of the carb has/is connected to the pilot jet system and the idle system, the passages that use this system must be perfectly clean for the engine to run properly.... the air screw has a spring. a spring seat and a o-ring for sealing on it.. the screw setting starts at 1 & 1/2 turns out from lightly seated.. then set the screw in the very side of the carburetor (its the one that controls the idle speed).. once you get the machine warmed up and cleaned out.. let it idle, turn the air screw in and out SLOWLY about a 1/4 turn at a time..EACH TIME ..waiting until the idle settles and then until you reach the point the machine idles as high as possible, then turn in it 1/8 of a turn.. then set the idle speed with the "side screw" to a speed you like... good luck...thanks!!

Jul 17, 2017 | ATVs

1 Answer

What is the timing set to on a 98 arctic cat 300 4×4


Hi, Anonymous sorry you can't find the first and best tool you ever bought for your Yamaha despair, not for a mere $10 you can download another one. For more information about your issue and valuable "FREE" downloads that you will need please visit the websites below. Good luck and have a nice day.
help with timing
ATV Connection
http://www.r6messagenet.com/forums/pdf/99-02R6_Service_Manual.pdf
https://www.tradebit.com/filedetail.php/105822591-arctic-cat-atv-service-manual-repair-2003

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/gregg_c0ec1df182c7330e

Mar 25, 2016 | ATVs

4 Answers

Why does the carb keep flooding?


In the absence of something like a faulty or porous casting of the carb allowing fuel to bypass the float valves then sticking or leaky float valves, sticking or punctured floats or an excessive fuel line pressure must be the problem.

Where no isolating tap is fitted to a gravity feed system the float valves must be virtually perfect and the only way to ensure perfect seating is to examine the surfaces under a strong magnification and then verify correct seating by using a vacuum pump and gauge.

An excessive line pressure can be caused by a blocked fuel tank breather.

Apr 19, 2015 | ATVs

1 Answer

What all can cause gas to run out the carb overflow line.


There is a bunch of things including, Hole in float, Dirty gas has left deposits on the needle and doesn't allow a complete shutoff, A damaged needle or seat, If carburetor has been taken off the float setting could be off, gas breaking down leaving a deposit on the needle or seat. Usually can be cured with a good cleaning and a new needle and seat. Check float to be sure it doesn't have a hole in it. If using 10% ETHANOL. fuel the fuel can be damaging your carburetor. I have had it eat a hole in the bottom of one of my carburetors so it does happen. I do not use ethanol fuel in any of my 4x4's anymore. May be more but good cleaning is needed.

Mar 13, 2015 | Polaris 2008 Sportsman 500 H.O

2 Answers

Why does my yamaha 660 only run if the choke is on? What causes it to backfire?


Most of the time it's because the Pilot/Idle jet is clogged in the carburetor. This most often happens because of old fuel sitting in the carburetor during long periods of sitting and non-use. The fuel forms a varnish - a gummy layer inside of your carburetor and clogs the tiny holes in the idle jet. Since fuel can't get through, the engine dies. The hole for the choke is larger, therefore the fuel can still get through it.

clogged carb jets Google Search

Jul 20, 2014 | Yamaha 2005 Grizzly 660 Auto 4x4

1 Answer

My 2010 polaris 500 ho dies when i let off the gas


Turn idle adjustment up, if stalling persist remove and clean carburetor.
Check the attached links,Manuals and guides, Good luck with your Bike
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

ATV TROUBLESHOOTING AND MAINTENANCE
Service Manuals for Download in PDF
ATV Service and Repair Manuals

Feb 03, 2014 | Polaris 2010 Sportsman 500 H.O

1 Answer

Arctic cat atv problems


If it has in line fuel filter it may be clogged also if tank is located in the rear you may have fuel pump problem. Most that set forward or above engine are gravity fed and have fuel on and off be petcocks with screen type filter in small bowl at bottom which can be removed and cleaned. The screen will above bowl threads in the petcock. Hope this helps,

Jan 26, 2014 | ATVs

1 Answer

2005 suzuki ozark


Hey Bayside,,
Sounds like the carburetor needs the attention of a qualified professional..install a new (correct) spark plug,,
Have the pro clean, check, and set the carburetor, you should be ok,,

Sep 14, 2017 | Suzuki 2005 Ozark 250

3 Answers

Grizzly 660 will not start


the float valve maybe stuck and not letting fuel into the bowl

Jun 07, 2009 | RTO 200cc Full Size Four Wheeler ATV

Not finding what you are looking for?
Suzuki 2005 QuadSport Z400 Logo

Related Topics:

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki ATVs Experts

Randy Wolkowski
Randy Wolkowski

Level 1 Expert

2 Answers

Marvin
Marvin

Level 3 Expert

85020 Answers

Lawrence Oravetz

Level 3 Expert

10543 Answers

Are you a Suzuki ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...