Were is the marking to line up your timing belt on my kymco 450 le atv

Question edited for clarity.
Question moved to model category.

no spark.

KymcoForum.com https://www.kymcoforum.com > ...
Jan 10, 2015 - Try un-plugging the rectifier, and see if you get spark. It may be shorting the stator to ground. Also try clipping the black, and yellow ...

Power to coil but no spark. What can it be?
Jun 11, 2016
Kymco 150 bogging down
Mar 27, 2014
wiring schematic for 05 mxu 150
Jun 23, 2014
suspected faulty kill switch
Jan 16, 2015
More results from www.kymcoforum.com

No Spark At Spark Plug - KYMCO MXU 150 Service Manual

ManualsLib https://www.manualslib.com > ... > Service manual
KYMCO MXU 150 Manual Online: No Spark At Spark Plug. Inspection/Adjustment ... Check ignition coil with. a CDI unit tester. 1-37. Symptom. Weak or no spark. Not ...

Missing: 2007 ‎' Show results with: 2007

KYMCO SERVICE MANUAL

ATV Scooter Parts https://atvscooterparts.com > atv > mxu150-m
Jun 8, 2005 - No power. Intermittent power. • Dead battery. • Loose battery cable ... LIGHTS/ SWITCHES. 17-6. ATV 150/125. MXU 150: INSPECTION. Disconnect the ...
244 pages
..

Visit the on-line store, know as https://www.heavy-equipmentmanual.com/, they have the repair manuals. I'm sure you will get the solution of your problem.

disconnect hose line no drain valve

belt drive ? or chain. ? belt slipping ? sprocket on chain loose?

Installing a hardtop on a 2014 Kymco UXV 700i ATV may vary depending on the specific hardtop you have. However, here are some general steps you can follow:

1. Gather all necessary tools and equipment, including a drill, screws, and any other hardware that comes with the hardtop.
2. Place the hardtop on top of the ATV and align it with the mounting points.
3. Use the provided hardware or screws to secure the hardtop to the ATV. Make sure the hardtop is securely attached and level.
4. Check that all screws and bolts are tightened properly and that the hardtop is securely attached.
5. Test the hardtop to ensure it is properly attached and does not move or shift while in use.

It is recommended that you refer to the installation manual that came with your hardtop for specific instructions and to proceed with caution to not cause any damage to your ATV.

whats the old plug look like? google for images to tell you whats going on.

valves are set of TDC mark

If its carborated check the float level.

that was my first thought, belt is slipping or pully is polished smooth.

Hi Matt only help I can give is look along top & bottom of chain for a tensioner it will be a round rubber wheel. If you cant find a tensioner it will more than likely you need to cut the chain down. If your not sure how to let me know & i'll let you know how. Also DO NOT USE IT while chain is loose as if you do & chain comes off you can crack engine case which then means a new engine