SOURCE: 2009 arctic cat 4x4 auto 500
Unless you have a few special tools...flywheel remover, case splitters, crank installer, clutch tool, factory service manual.etc.. TAKE it to a professional!!
SOURCE: 2004 arctic cat 500 4x4 starter turns doesnt engage starts with pull cord
1. Never jump start an ATV, Motorcycle, UTV..etc from a automobile! The amperage is TOO high, you can damage a lot of expensive electrical components!! ..very quickly!
You cannot home trouble shoot without a new battery or fully charged battery with good solid clean connections!!
2. Have the battery tested or simply buy a GOOD new one!
3. Does the starter spin at all? Is there a clicking noise when you push the start button? No - solenoid is bad(?) . you can check this by jumping the two large connectors on the solenoid... A good screwdriver works well...(CAREFUL - SPARKS WILL FLY!) If the starter works while jumping, the solenoid is bad - just replace it (disconnect battery while replacing).
4. If the start spins while "jumping" and nothing happens the starter may need rebuilding if the new battery/fully charged battery/jumping solenoid does not expose/solve the problem.
Do this and repost.
Steve
SOURCE: I have a 2002 arctic cat atv 4x4 and every time i turn the key on it blows the ignition fuse.
Unplug wires going to stater, starter, and any other wire you can find related that could be grounded when ignition is in run position. As well as any after market things like hand warmers, winch, light's. Keep unplugging things until fuse doesn't blowing then start hooking up one at a time till you find the problem. If you have a meter you can check some of these items to see if there shorted out or just get a bunch of fuses and try other way mentioned. Do Not use larger fuses as a matter of fact you can use a slight lower amp fuse for testing.
SOURCE: How to fix a leak fuel from the carbuator or primer for a atv arctic cat 500 2005
I am laughing at some of these "fixes".. remove the carburetor, take it to the dealer, he will know what you need. There is a rebuild kit (or new plunger kit) for this pump.. you MIGHT be able to clean it and replace the o-ring (NOT WITH A BIGGER ONE) - but the correct one..I know this is a pain in the a$$.. let a professional repair/fix it instead of guessing..
458 views
Usually answered in minutes!
×