ATVs Logo

Related Topics:

2002 Yamaha Kodiak 400. How can I press magneto back onto crank?

Had to pull magneto to get to timing chain.

  • David Pritchard
    David Pritchard Apr 17, 2016

    Thanks andrew! I was afraid I was not doing something right or going to have to but a special tool.

×

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2002 Yamaha Kodiak 400 will not hold low idle.

get a colortune tool.it shows how your firing.read instructions that come with,so simple to tune carb in with.sounds like pilot out of adjustment.could also have a leak in ur carb boot or head.take a torch without lighting open valve with motor running run torch around gaskets and front of carb boot listen for change in motor.if it gets higher rev uve found a leak.
0helpful
1answer

2003 Yamaha Kodiak 400 back fires and kills. This happens on full throttle. What could could be the issue?

The high speed jet isn't rich enough or the carb passages needs to be cleaned. You can move the clip down one spot on the needle so it gets more gas, this will also give you more power at the top end.
0helpful
1answer

1999 Yamaha Kodiak 400 4+4 best way to set motor timing and valves

check youtube for generic valve adjusting procedures, the kodiak is like most of them.
0helpful
1answer

98 kodiak 400 4x4 wants to back fire at full throttle choking it helps a little

your carb needs cleaned/adjusted. your float could be set wrong. could be an air leak somewhere.
0helpful
1answer
0helpful
2answers

Kodiak 400 metal in oil

Hey.. sounds like you are on the right track..

DO NOT CRANK THIS ATV AGAIN!!
GET IN TOUCH WITH A PROFESSIONAL MECHANIC.
If you are going to do it... remove the engine..its going to have to be totally disassembled to make sure ALL the metal and rubber pieces are COMPLETELY removed. This will also provide you with the evidence for a parts list for replacements parts and pieces as you take it apart..slowly.. Clean parts make for a clean engine.. watch for small oil passages and any little nooks and crannies in the cases that will pack with ground up metal..COMPRESSED AIR and long wooden swabs work wonders.

ps.. replace the cam chain no matter what it looks like!!!!!
Not finding what you are looking for?

71 views

Ask a Question

Usually answered in minutes!

Top ATVs Experts

john h

Level 3 Expert

29494 Answers

Renee Knafel-Bullock

Level 3 Expert

404 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you an ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...