Question about Polaris ATV

Open Question

I Can't seem to get my four-wheeler to start,it's a Polaris.

Last Time I rode it started to skip and keep on shutting off on me and now it want even start.

What parts do I need to order?

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 93 Answers

SOURCE: 1986 polaris 4 wheeler 250 gas leak. Need a manual in how to

Find a Clymers or Haynes manual for it at a Checker or Auto Zone or go online to find one.

Posted on Sep 11, 2009

  • 1 Answer

SOURCE: lost low on polaris 4 wheelers heard a pop and no more low

how do you fixs pull ropes for yamaha kodak

Posted on Nov 22, 2009

  • 1978 Answers


You need a new head gasket. Also check that your head is not warped.

Posted on Aug 23, 2010

  • 1 Answer

SOURCE: how do you get a starter off a polaris explorer 300 four wheeler?

for a 2001 polaris xplorer, you need to remove the body, the drive belt cover, both the drive clutch and the driven clutch. to remove the drive clutch I went to napa auto parts and bought a 3/4 x6 inch fine threaded bolt. I removed the bolt for the clutch. I then inserted 1 long and 1 short 12mm sockets into the center of the clutch. then threaded the 3/4 bolt until it was tight gave it a few light wacks with a small sledge hammer, turn it some more and it popped right off. alot easier than buying the polaris puller. the driven clutch came right off no problem. you need to remove the back palstic part of the drive belt case. three bolts behind where the driven pulley was and another screw connected to the foot rest. make sure you remove the negative battery terminal. you then need to unscrew the bracket on the back of the starter and remove it. next I stood the quad up on its rear tires and back frame.Put an oil pan orsomething underneath the back frame bar as some of the premix oil leaked while it was in this position. remove the skid plate. pull back the rubber boot on the starterand remove the wire. go back around to the side and remove the two hex headed screws from the back of the starter. at this point the starter housing should come right off. then I pulled it out. I replaced it in reverse. make sure the o-rings are on correctly. I really hope that this helps some of you out there. One note I purchased an aftermarket starter that was connected to a cast aluminum housing that i assume houses the pinion gear. but i had to remove that part and only install the back part of the starter.

Posted on Jan 20, 2011

  • 9 Answers

SOURCE: I have a 2004 Polaris 400. 4-wheeler. The bike

You have a faulty switch, or it has corrosion in it, moving the switch through it's full travel rapidly for a while to clean the inner contacts may cure the problem, or try disconnecting the switch.

Posted on Sep 23, 2013

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Wont start or stay running unless battery charger is on it

some four wheelers require a battery to run correctly. sounds like you need a new one.

Mar 26, 2014 | ATVs

1 Answer

Four wheeler

if your four wheeler is back firing you may have water in your gas or your gap on the plug

Dec 06, 2013 | ATVs

1 Answer

Four wheeler

Could be a CV axle if worse when turning tight it's a front sounds like a rear tho.

Aug 27, 2013 | ATVs

1 Answer

Wiring polaris trail blazer 250 diagram

There are several places you can go on the web that have free atv repair/owners manuals. The owners manuals usually have a wiring schematic on or towards the last page also trouble shooting diagrams with instruction in them.

Type in your search bar: atv polaris (year) model:trailblazer/500cc.
If you like email: with specs and I will email it to you.

Hope this was helpful

Jul 07, 2012 | RTO 200cc Full Size Four Wheeler ATV

3 Answers

We have a New ATV 250cc that will not start..getting fuel,getting spark, engine just turns over!

  1. eHow
  2. Car Repair & Maintenance
  3. Car Oil Maintenance
  4. Drain Car Oil
  5. How to Repair a Polaris Four Wheeler
How to Repair a Polaris Four Wheeler By Brianna Byrne, eHow Contributor repair-polaris-four-wheeler-800x800.jpg Spark plug inspection and adjustment can be one way to repair a Polaris ATV.

Almost every vehicle needs regular servicing and repairs in order to continually perform at its best, and Polaris' lineup of four wheelers is no exception. The company has released dozens of ATV makes and models throughout the years, ranging from sporty racing quads to youth models to heavy-duty utility ATVs. Despite the differences between the company's many makes and models, general repair tips and troubleshooting instructions remain consistent for all Polaris four-wheelers. The electrical, ignition and fuel systems are some of the most common sources of Polaris ATV problems.

Read more: How to Repair a Polaris Four Wheeler '

Nov 21, 2009 | RTO 200cc Full Size Four Wheeler ATV

1 Answer

2009 sportsman 500 efi

Hey Shaun,
Since we cannot hear any sounds, its going to be hard to diagnose on here. I would take it to my dealer and ask the service manager to listen and go from there..

Aug 22, 2017 | Polaris ATV

Not finding what you are looking for?
Polaris ATV Logo

Related Topics:

99 people viewed this question

Ask a Question

Usually answered in minutes!

Top Polaris ATVs Experts

john h

Level 3 Expert

15190 Answers

Matt Olenzek
Matt Olenzek

Level 2 Expert

297 Answers

Wade Mobley
Wade Mobley

Level 3 Expert

513 Answers

Are you a Polaris ATV Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides